PDF4PRO ⚡AMP

Modern search engine that looking for books and documents around the web

Example: stock market

Concord 4 Installation Manual - Interlogix

Siren driver Output that can drive an 8-ohm load and provides intrusion and fire alarm sounds for partition 1 (15 watts maximum). Two onboard outputs Can be used to activate other signaling devices based on system events. Out 1 is a 9 to 14 VDC source output, limited to 1.0 amp max.

Fullscreen Download

Tags:

  Fire, Lamar, Fire alarm, Concord, Concord 4

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Spam in document Broken preview Other abuse

Documents from same domain

Concord 4 Installation Manual - Interlogix

static.interlogix.com

Total system power and wire length guidelines The panel can supply up to 1 amp (1,000 mA) in full load alarm condition for system devices connected to panel terminals 4 (+12V), 7 and 8 (speaker terminals), 9 (OUT1), 11 (+12V), 24 (2W SMK ZONE 8), and SnapCard terminals. For 24-hour backup, the total standby current draw for all devices connected to

  Power, Standby, Concord

SuperBus 2000 2X16 LCD Alphanumeric Touchpad …

static.interlogix.com

SuperBus 2000 2X16 LCD Alphanumeric Touchpad Installation Instructions . Product summary . The SuperBus ® 2000 2x16 LCD (liquid crystal display) Alphanumeric Touchpad lets you control all programming and

  Installation, Instructions, Installation instructions

NX-8V2 Control Panel Installation Manual

static.interlogix.com

LED keypad programming 11 Control panel programming 14 ... overview of the product and detailed instructions explaining how to install the NX- ... 1 A maximum load. A 3.3 kohm resistor is required across the bell terminals when a 12 VDC siren is used. If no resistor is used, you may experience voltage leakage into the

  Installation, Instructions, Load

NX-8E Control Panel Installation Manual

static.interlogix.com

NX-8E Control Panel Installation Manual 11 LED keypad programming This section describes how to program the address of each LED keypad, as well as the options that are available. The keypad must be addressed for control panel supervision of that keypad. Programming defaults include: • Four-digit master code: 1, 2, 3, 4.

  Manual, Programming, Installation, Installation manual, Keypads, Keypad programming

TruVision NVR 10 User Manual - Interlogix

static.interlogix.com

• TruVision NVR 10 User Manual (on CD) • TruVision Recorder Operator Guide (on CD) Back panel The figures below show the back panel connections and describe each connector on a typical NVR 10 digital video recorder. Details may vary for specific models. Before powering up the recorder, connect the cameras and a main monitor for basic operation.

  User, Video, Digital, Recorder, Digital video recorder

Simon XT User Manual - Interlogix

static.interlogix.com

FCC Part 15 registration number: B4Z-910C-SIMON. Part 68. This equipment complies with Part 68 of the FCC rules and the requirements adopted by ACTA. A label on this equipment contains a product identifier in the format US:AAAEQ##TXXXX. You must provide this number to the telephone company upon request.

  Simon, Simon xt

TruVision IP Camera Configuration Manual - Interlogix

static.interlogix.com

1BChapter 2: Camera operation 12 TruVision IP Camera Configuration Manual . Configuring network settings . Accessing the camera through a network requires that you define certain network settings. Use the “Network” folder to define the network settings. See Figure 5 and Table 4 below for further information.

  Camera