Transcription of NX-8E Control Panel Installation Manual
{{id}} {{{paragraph}}}
Example: air traffic controller
NX-8E Control Panel Installation Manual
P/N I-NX8E-IM REV C ISS NOV12 NX-8E Control Panel Installation Manual Copyright 2012 UTC Fire & Security Americas Corporation, Inc. Interlogix is part of UTC Climate Controls & Security, a unit of United Technologies Corporation. All rights reserved. This document may not be copied in w hole or in part or otherw ise reproduced w ithout prior w ritten consent f rom UTC Fire & Security except w here specifically permitted under US and international copyright law . Disclaim er The inf ormation in this document is subject to change w ithout notice. UTC Fire & Security assumes no responsibility f or inaccuracies or omissions and specif ically disclaims any liabilities, losses, or risks, personal or otherw ise, incurred as a consequence, directly or indirectly, of the use or application of any of the contents of this document.
NX-8E Control Panel Installation Manual 11 LED keypad programming This section describes how to program the address of each LED keypad, as well as the options that are available. The keypad must be addressed for control panel supervision of that keypad. Programming defaults include: • Four-digit master code: 1, 2, 3, 4.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: