Transcription of Cutting data recommendations - Uddeholm Global
{{id}} {{{paragraph}}}
Example: confidence
Cutting data recommendations - Uddeholm Global
Cutting data RECOMMENDATIONSU ddeholm CorraxMachining data are always dependent on the actual operation, the machine tool and the Cutting data used. The machining data given is this datasheet are general guidelines that may have to be adjusted to the actual conditions of a specific machining data formulaeTurningLegendvc= Cutting speed (m/min)n= Spindle speed (rev/min)f = Feed per rev (mm/rev)ap= Axial depth of cut (mm)D= Workpiece diameter (mm)Q= Material removal rate (cm3/min)Ra= Surface roughness ( m)re= Nose radius (mm)MillingLegendvc= Cutting speed (m/min)n= Spindle speed (rev/min)vf= Feed speed (mm/min)ap= Axial depth of cut (mm)ae= Radial depth of cut (mm)f = Feed per rev (mm/rev)z= Number of teethfz= Feed per tooth (mm/tooth)D= Cutter diameter (mm)hm= Average chip thickness (mm)Q= Material removal rate (cm3/min)DrillingLegendvc= Cutting speed (m/min)n= Spindle speed (rev/min)vf= Feed speed (mm/min)D= Drill diameter (mm)f = Feed per rev (mm/rev)Material removal rate Q v a fcp,()= cm / min3 Feed speed vf nf,()= mm / min3,0)
The machining data given is this datasheet are general guidelines that may have to be adjusted to the actual conditions of a specific machining operation. Cutting data formulae Turning Legend v c = Cutting speed (m/min) n = Spindle speed (rev/min) f = Feed per rev (mm/rev) a
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: