PDF4PRO ⚡AMP

Modern search engine that looking for books and documents around the web

Example: marketing

Data Sheet ±15kV ESD-Protected, 3.3V, 1/8 Load, Failsafe ...

ESD protected up to ±15kV (Air-Gap and Human Body Model) and up to ±8kV Contact Discharge (IEC 61000-4-2). The SP3070E - SP3078E devices may not achieve optimal transmit performance if the connected receiver includes a biasing network to 5.0V without a termination resistor. Please see MaxLinear Application Note ANI#21 for further details.

Fullscreen Download

Tags:

  Model, Human, Body, Human body model

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Spam in document Broken preview Other abuse

Documents from same domain

SP3222E / SP3232E Datasheet

assets.maxlinear.com

ESD tolerance of the SP3222E / SP3232E devices are over ±15kV for both Human Body Model and IEC61000-4-2 Air discharge test methods. The SP3222E device has a low-power shutdown mode where the devices’ driver outputs and charge pumps are disabled. During shutdown, the supply current falls to less than 1µA. Typical Applications

  15kv

Related documents

User Guide of ANSI/ESDA/JEDEC JS-001 Human Body Model ...

www.jedec.org

Human Body Model Testing of Integrated Circuits Authors: Joint HBM Working Group ESD Association and JEDEC Solid State Technology Association Electrostatic Discharge Association 7900 Turin Road, Bldg. 3 Rome, NY 13440 JEDEC Solid State Technology Association 3103 North 10th Street Arlington, VA 22201

  Model, Human, Discharge, Body, Electrostatic, Electrostatic discharge, Human body model

IEC 61000-4-2 ESD S

www.silabs.com

RF radio chips are designed for and tested against the different chip-level ESD standards such as Human Body Model (HBM), Machine Model (MM) and Charged Device Model (CDM). These chip-level test results are summarized in the RF IC’s Qualification Report.

  Model, Human, Body, 61000, Human body model, Iec 61000 4 2 esd

System Level ESD Expanded - JEDEC

www.jedec.org

•Actual human contact to an IC component is simulated / tested with the Human Body Model Tester, which results in ESD stress between two or more component pins. •This is completely different from the IEC Test method where the Zap Gun is used to test a system case, board or board connector and may or may not stress an IC.

  Model, Human, Body, Human body model

System-Leve ESD Protection Guide (Rev. C)

www.ti.com

4 System Level ESD Protection Guide Texas Instruments 2018 £ Semiconductor devices based off of advanced processes only offer device-level ESD specifications like the charge device model (CDM) and the human body model (HBM) shown below . Device-level ESD specifications are not sufficient to protect devices in a system . The energy associated ...

  Model, Human, Texas, Texas instruments, Instruments, Body, Human body model

PESD1CAN CAN bus ESD protection diode - Nexperia

assets.nexperia.com

CAN bus ESD protection diode [1] Device stressed with ten non-repetitive ESD pulses. [2] Measured from pin 1 to 3 or 2 to 3. Table 6. ESD maximum ratings Symbol Parameter Conditions Min Max Unit Per diode VESD electrostatic discharge voltage IEC 61000-4-2 (contact discharge) [1][2]-23kV MIL-STD-883 (human body model)-10kV Table 7. ESD standards ...

  Model, Human, Discharge, Body, Electrostatic, Electrostatic discharge, Human body model

EMI, EMC, EFT, and ESD Circuit Design Consideration for …

ww1.microchip.com

2. Electrostatic Discharge (ESD) IEC 61000-4-2 Most digital non-interface components and microcontrollers are only warranted for 2 kV Human Body Model (HBM). This is acceptable in most cases for interconnected signals between ICs on the same printed circuit board (PCB) that share the same ground. High risk exceptions are microcontroller

  Model, Human, Discharge, Body, Electrostatic, Electrostatic discharge, Human body model

The Prevention and Control of Electrostatic Discharge (ESD ...

www.minicircuits.com

the human body, it can be very damaging to electronic devices which are sensitive to electrostatic discharge (ESD). It is possible for electronic devices to be damaged by ESD that is imperceptible to the human body. This document is intended to shed some light on the sources of ESD and provides guidelines on the prevention and control of ESD.

  Human, Discharge, Body, Electrostatic, Electrostatic discharge, Human body

Related search queries

Human Body Model, Electrostatic discharge, IEC 61000-4-2 ESD, Model, Human, Texas Instruments, Human body