Transcription of DESCRIPTION PAGE - Sigma Fasteners
{{id}} {{{paragraph}}}
Sigma Fasteners , Inc. Section 2 DESCRIPTION PAGE B7 Studs and Nuts Stud Bolts for Pressure-Temperature Piping 2-1 General Purpose End-to-End Studs 2-2 Tap End Stud Bolts 2-3 Double End Stud Bolts 2-4 Sigma Fasteners , Inc. Section 2 Page 1 STUD BOLTS FOR PRESSURE-TEMPERATURE PIPING Stud bolts for Pressure-Temperature Piping REFERENCE Stud bolts for pressure-temperature applications conform to the requirements of ANSI/ASME , Steel Pipe Flanges and Flanged Fittings. LENGTH-FIRST TO FIRST The length of stud bolt, measured parallel to the axis, is the distance from first thread to first thread. First thread is defined as the intersection of the major diameter of the thread with the base of the point. Please see the drawing above-this is confusing to most users!! Stud bolts are normally available in 1/4 in. length increments. Length tolerances, all stud bolt sizes, shall be as tabulated below: Length, in. Length Tolerance, in. to 12 over 12 to 18 over 18 + + + POINTS Points shall be flat and chamfered, or sheared at option of the manufacturer.
© Sigma Fasteners, Inc. Section 2 Page 2 GENERAL PURPOSE END-TO-END STUDS Continuous Thread Studs (General Purpose) LENGTH The length of …
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}