USER´S MANUAL HAKI STAIR TOWER

ERECTION 6. Lift up the erection platforms to the next level and install the next set of standards, transoms and ledger beams for the third lift. Install toeboards. 7. Install guardrail frames to next lift using AGR tools. 8. From the erection platforms, install the next landing. Remove the top guard frame. Install a stair flight, hand-

  Manual, Stair, Frame, Towers, Erection, Haki, Manual haki stair tower

Storefront Installation Instuctions

Series 401,402, & 403 Installation Instructions Single Acting Use W138 Door Frame Parts: Drawings on this page are not to scale. SECTION II: A. S401 PARTS IDENTIFICATION FS92 3” Perimeter Adaptor Clip Use W/ 401 Open Back Frames 9109 Door jamb Use W138 Weathering 9108 Double Acting Door Jamb 9112 1/8” Wall Weathering Single Acting Door Jamb

  Instructions, Frame

5. External Wall Construction

(refer to manufacturer’s instructions on the mix ratio) should be applied to the dampened surface; and d) non-shrink grout should be used to seal the holes. The slurry coat should still be fresh at time of application of mortar. 29 external wall construction Figure 5.6: Joint surface roughened to improve bonding at RC-RC joint

  Instructions

Formwork Code of Practice 2016 - WorkSafe.qld.gov.au

Formwork Code of Practice 2016 (PN11965) Page 5 of 54 Foreword This Formwork Code of Practice 2016 is an approved code of practice under section 274 of the Work Health and Safety Act 2011 (the WHS Act). An approved code of practice is a practical guide to achieving the standards of health, safety and