Transcription of Digital signal processing for STM32 microcontrollers using ...
{{id}} {{{paragraph}}}
February 2018AN4841 Rev 21/251AN4841 Application noteDigital signal processing for STM32 microcontrollers using CMSIS IntroductionThis application note describes the development of Digital filters for analog signals, and the transformations between time and frequency domains. The examples discussed in this document include a low-pass and a high-pass FIR filter, as well as Fourier fast transforms with floating and fixed point at different associated firmware (X-CUBE-DSPDEMO), applicable to STM32F429xx and STM32F746xx MCUs, can be adapted to any STM32 signal processing (DSP) is the mathematical manipulation and processing of signals.
DSP operations can use either floating-point or fixed-point formats. 1.1.1 Floating point Floating point is a method to represent real numbers. The floating point unit in the Cortex®-M4 is only single precision, as it includes an 8-bit exponent field and a 23-bit fraction, for a total of 32 bits (see Figure 1). The floating point
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
Data sheet, Fixed and floating point DSP, Fixed, Point and floating, Point, Floating, Digital Signal Processors, FIXED POINT, FLOATING POINT, Fixed point DSP, Digital Signal Processor, Architecture, UltraScale Architecture DSP, UltraScale architecture, Xilinx, Fixed and floating point, INTERRUPTS, And floating, Floating-Point Operator, SHARC+ Core Programming Reference, Analog Devices