Transcription of Dimensioning and Tolerancing, Section 6, Drafting …
{{id}} {{{paragraph}}}
Example: barber
Dimensioning and Tolerancing, Section 6, Drafting …
Drafting manual Section Update 56 Dimensioning and tolerancing Page 1. Update 56 A. Wilson by: Bruce Symbols February 1997*. SYMBOLS Diameter - A diameter symbol is placed in front of any GENERAL1 dimension value that is a diameter. See Figure 2. This Section is based on ASME Symbols unique to ANSI are also described for those who are contractually obligated to comply with the older standard. Symbols permit consistency in the way dimensions and tolerances are specified, and each symbol has a clearly defined meaning. Symbols take less time to apply on a drawing than would be required to state the same requirements with words. The symbols also require considerably less space.
Section 6.1 DRAFTING MANUAL Page 2 Dimensioning and Tolerancing August 1993* Symbols Update 47 2.4 Depth - A downward-pointing arrow is used for the depth symbol, and it is placed in front of the depth value in such …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Engineering Drawing Standards Manual, Engineering, MANUAL OF ENGINEERING DRAWING, Standards, Engineering Standards, Structural Detailing Standards, Drawing, Xxx xxx App 879605, Engineering drawing, DRAFTING MANUAL, Manual, Engineering Drawings, Engineering Drawing Practices, Engineering Drawing Practices Engineering Drawing