Master Products Catalog - Gates Corporation

the entire serpentine drive. Neglecting to replace the tensioner and pulley(s) at the same time you replace the belt can ultimately shorten the life of the belt as well as other front-end accessory components. Each kit contains an OE-equivalent belt, tensioner, idler pulley and necessary hardware with installation instructions and tech

  Product, Catalog, Drive, Master, Corporation, Front, Gate, Gates corporation, Master products catalog

Timing Belt Replacement Interval Guide - Gates Corporation

Today, Gates is the world’s largest manufacturer of Timing Belts and Timing Component Kits (TCKs). Import or Domestic, if there is a car in the U.S. with a timing belt in it, we have the replacement part for it. As the OE or OES supplier for virtual every vehicle manufacturer worldwide, you can be confident every time you install Gates.

  Guide, Vehicle, Replacement, Corporation, Gate, Belt, Timing, Interval, Timing belt replacement interval guide, Gates corporation

Gates Powersports Recreational Belt Applications

Gates 1144 15th Street, Suite 1400 Denver, CO 80202, U.S.A. 303.744.1911 POWERSPORT RECREATIONAL BELT APPLICATIONS WEATHERLY NO. 400 CATALOG NO. 431-2070

  Applications, Recreational, Belt, Recreational belt applications

BELT I.D. CHART - Gates Corporation

SYNCHRO-POWER™ POLYURETHANE BELTS Example: T5-270-8 Synchro-Power Belts A T2.5 2.5mm.098 in. T5 5mm.197 in. T10 10mm.394 in. AT5 A5mm.197 in. AT10 10mm.394 in. DT5 5mm.197 in. DT10 10mm.394 in. A 270H075U Synchro-Power Timing Belts A MXL 2.03mm.080 in. XL 5.08mm.200 in. L 9.53mm.374 in. H 12.70mm.500 in. A POLY CHAIN & …

  Corporation, Gate, Belt, Gates corporation

Industrial Hose, Couplings and Equipment Catalog

TERMS POLICY Terms are 2%, 30 days. Discount may be earned if paid on or prior to the 30th day following the invoice date. CONDITIONS › Prices do not include charges for special packaging, which will be extra, unless otherwise specified.

PC 707 Crimper - Gates Corporation

the crimp OD. Insert the coupling into the die set approximately 1/8” below top of die. (See Photo 1.) Slide the die cone assembly under the ram until it stops against back locating pins and push the crimp button and hold. Release the button immediately when the pump stops. Remover coupling and measure crimp diameter, which

  Corporation, Gate, Crimp, Gates corporation

3 4 5 6 7 8 9 10 11 12 13 14 15 - SDP/SI

SECTION 10 BELT TENSIONING ... SECTION 21 DRIVE RATIO TABLES ... The tooth profile of most commonly known synchronous belts is of trapezoidal shape with sides being straight lines which generate an involute, similar to that of a spur gear tooth. As a result, the profile of the pulley

  Table, Belt, Synchronous, Tensioning, Belt tensioning