Transcription of ELECTRIC DUCT HEATER - RenewAire
{{id}} {{{paragraph}}}
Example: marketing
ELECTRIC DUCT HEATER - RenewAire
RenewAire ERV + ELECTRIC DUCT HEATER : A SINGLE-SOURCE SOLUTIONHEATERE L E C T R I C D U C TEVERY GEOGRAPHY, EVERY CLIMATE, EVERY HOME, EVERY BUILDING AND EVERY APPLICATIONRENEWAIRE EVERYWHEREFLIPPABLE EK SERIES SHOWNRH SERIES RH-W SHOWN2 OPTIONS & ACCESSORIESS pecifications may be subject to change without Type: ELECTRIC Duct HeaterTypical KW Range: 1 kW (1, 2, 3, 4, 5, 6, 8, 10, kW)Voltages & Phase:Single phase - 120, 208 and 240 VControl Voltage:24 VACC ontrollable Output Temperature Range: RH-D: 32 to 108 F RH-W: -3 to 130 FStandard Features: Open-coil elementHigh-grade, nickel-chrome element wireThermostat - Integral (RH-D), Wall mount (RH-W)Modulating heat output (SCR control)Vertical or horizontal operationAutomatic limit switch for primary over-temperature protectionManual reset limit switch for secondary over-temperature protectionAirflow sensorStandard control transformer - 24 VACC orrosion-resistant galvanized steelRound duct collarsHigh-voltage terminal block connectionsGrounding lugMounting flangesAccessories:Temperature sensor - Duct mount (DS-600)Digital time clock - wall mount (TC7D-W),in exterior enclosure (TC7D-E)Motion occupancy sensor/control - ceiling mount (MC-C), wall mount (MC-W)Note: ELECTRIC duct HEATER designed for indoor ductwork installation Duct HEATER ( kW)AccessoryELECTRIC DUCT HEATERD ownload specification Airf
Upon the restoration of power, re-energize the switches in a stepping sequence. Commonly used with a 2–10 vDC from a stand-alone T-stat, 2–10 vDC from a DDC building automation system and 4–20 mA from a building automation system.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: