Transcription of Factory Acceptance Testing Guideline - RISE
{{id}} {{{paragraph}}}
Factory Acceptance Testing Process Industry Guideline IEC 61511. Version: Last Edited:2006-08-25. Factory Acceptance Testing Guideline Comments on this report are gratefully received by Johan Hedberg at SP Swedish National Testing and Research Institute -1- Factory Acceptance Testing Process Industry Guideline IEC 61511. Version: Last Edited:2006-08-25. Summary According to the standard IEC 61551 the Factory Acceptance test (FAT) is not a requirement but is necessary to carry out if the application software of the logic solver is complex or if the architecture is using redundant arrangements. The general questions in the planning phase of the FAT concern the tests to be performed and how to deal with the tests.
Factory Acceptance Testing Guideline Process Industry IEC 61511 Version: 1.0 Last Edited:2006-08-25 www.sp.se/safeprod -7- design, hardware design, and software design will contribute the FAT planning with relevant test
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}