Transcription of FEDERAL STANDARD SCREW-THREAD …
{{id}} {{{paragraph}}}
FED-STD-H28A. 28 December 1994. SUPERSEDING. FED-STD-H28. 31 March 1978. FEDERAL STANDARD . SCREW-THREAD standards FOR FEDERAL services .. This STANDARD was approved by the Commissioner, FEDERAL Supply Service, General services Administration, for the use of all FEDERAL Agencies. Beneficial comments (recommendations, addition, deletions) and pertinent data which may be of use in improving this document should be addressed to: Defense Industrial Supply Center (Code DISC-ETT) 700 Robbins Avenue, Philadelphia, PA 19111-5096 by using the self addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter. AMSC N/A AREA THDS. DISTRIBUTION STATEMENTA. Approved for public release; distribution isunlimited FED-STD H28A. 28 December 1994. INFORMATION SHEET ON FEDERAL standards . This FEDERAL STANDARD is issued in loose-leaf form to permit the insertion or removal of new or revised pages and sections.
Dec 28, 1994 · FED-STD-H28A 28 December 1994 SUPERSEDING FED-STD-H28 31 March 1978 FEDERAL STANDARD SCREW-THREAD STANDARDS FOR FEDERAL SERVICES. This standard was approved by the Commissioner, Federal Supply
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}