DC Power Relays

High-voltage, High-current Loads • A compact relay (73 x 36 x 67.2 mm (L x W x H)) capable of switching 400-V 60-A DC loads. (Capable of interrupting 600 A at 300 VDC max.) • The switching section and driving section are gas-injected and hermetically sealed, allowing these compact relays to interrupt high-capacity loads.

  High, Voltage

CSM PCB Con CN J 1 3 - omronfs.omron.com

A-20 最新の商品情報・便利な情報は www.fa.omron.co.jp/ コネクタ 共通の注意事項 コネクタ 共通の注意事項 挿抜作業について ・通電中の挿抜作業時および抜去後に、コネクタの接点 …

  Nomor

CSM XM2 XM3 AC DS J 1 8 - omronfs.omron.com

2 最新の商品情報・便利な情報は www.fa.omron.co.jp/ XM2/XM3 Dサブコネクタ X M 2 ／ X M 3 注1. 1個のコネクタに固定具は2個必要です。 注2. 形XM3K/Lには取付できません。

  Nomor

Solid State Pressure Sensors D8M - omronfs.omron.com

Compact D8M solid state pressure sensors provide reliable detection for gas and air inflow for burner controls in water heaters, furnaces and other gas-fired devices.

  States, Solid, Sensor, Solid state

G6B - Omron

3 G6B PCB Power Relay G 6 B Models for Ultrasonically Cleanable Note: When ordering, add the rated coil voltage to the model number. Example: G6B-1114P-US DC5 However, the notation of the coil voltage on the produc t case as well as on the packing will be marked as @@ VDC.

Solid State Relays Common Precautions

2.Inductive Noise Do not wire power lines alongside the input lines. Inductive noise may cause the SSR to malfunction. If inductive noise is imposed on the input terminals of the SSR, use the following cables according to the type of inductive noise, and reduce the noise level to less than the must release voltage of the SSR.

  Power, Noise, Reduces

G7L - Omron

• Miniature size for maximum switching power, particularly for inductive loads. • Flame-resistance materials (UL94V-0-qualifying) used for all insulation material. • Quick-connect, screw, and PCB terminals, and DIN track mounting available. • Conforms to UL, CSA, TUV and meets IEC950. • Safety design with contact gap of 3 mm.

  Maximum, Load

G2RL - Omron

Test conditions: Shock is applied in ±X, ±Y, and ±Z directions three times each with without energizing the relays to check the number of malfunctions. Requirement: None malfuction 100 m/s2 Sample: G2RL-24 12 VDC Number of relays: 5 pcs Test conditions: Shock is applied in ±X, ±Y, and ±Z directions three times each with without energizing

  Tests

G6S - Omron

Electrical 100,000 operations min. for AC (at 1,800 operations/h with rated load) 100,000 operations min. for DC (at 1,200 operations/h with rated load) Failure rate (P level) (reference value) *3 10 μA at 10 m VDC Ambient operating temperature-40°C to 85°C (with no icing or condensation), and -40°C to 70°C (with no icing or condensation)

  Electrical

G2R - Omron

3 G2R PCB Power Relay G 2 R Quick-connect Terminal (#187) Full-wave Rectifier For Ultrasonically Cleanable Note: When ordering, add the rated coil voltage to the model number. Example: G2R-1A-T AC12 However, the notation of the coil voltage on the produc t case as well as on the packing will be marked as @@ VAC.

  Terminal

Low-Peak™ LP-CC Class CC 600 Vac/300 Vdc, 1/2-30 A time ...

Low-Peak™ LP-CC Class CC 600 Vac/300 Vdc, 1/2-30 A time-delay fuses Catalog symbol: • LP-CC-(amp) Description: Bussmann™ series Ultimate protection Low-Peak Class CC current-limiting, time-delay fuses. Time-delay – 12 seconds (minimum) at 200% of rated current. Specifications: Ratings • Volts • 600 Vac • 300 Vdc (1/2 to 2-8/10 A ...

  300 vdc

12-800 Vdc Contactor GV200 - GIGAVAC

12-800 Vdc Contactor ADVANCED SWITCHING SOLUTIONS Rev 9 16/feb/ 2. DC POWER SWITCHING CYCLES 100 1,000 10,000 100,000 1,000,000 50 100 150 200 250 300 350 CYCLES CURRENT (A) 24V 300V 450V 600V 800V POWER SWITCHING COIL RATINGS at 25˚C Coil P/N Designation B 10/ C 10/ F 10/ M N P 4/ Q 4/ Coil Voltage, Nominal 12 VDC ...

Power Source - Miller

300 A. Max. Open-Circuit Voltage . 60 VDC. Rated Output. 300 A at 22 V, 30% duty cycle . 210 A at 18 V, 60% duty cycle Machine only: 101 lb. (45.8 kg) With Cooler and Running Gear: 176.4 lb. (80 kg) Industrial Applications. Precision metal fabrication. Maintenance and repair. Shipbuilding. Tube and pipe Automotive Vocational. Issued April 2021 ...

RF Power LDMOS Transistors High Ruggedness N--Channel ...

CW: Case Temperature 76 C, 300 W CW, 50 Vdc, IDQ = 50 mA, 40.68 MHz R JC 0.55 C/W Thermal Impedance, Junction to Case Pulse: Case Temperature 74 C, 300 W Peak, 100 sec Pulse Width, 20% Duty Cycle, 50 Vdc, IDQ = 100 mA, 230 MHz Z JC 0.13 C/W Table 3. ESD Protection Characteristics Test Methodology Class

MMBT2222LT1 - General Purpose Transistors

Vdc Collector−Base Voltage MMBT2222L MMBT2222AL, SMMBT2222AL VCBO 60 75 Vdc Emitter−Base Voltage MMBT2222L MMBT2222AL, SMMBT2222AL VEBO 5.0 6.0 Vdc Collector Current − Continuous IC 600 mAdc ... 300 2.4 mW mW/°C Thermal Resistance, Junction−to−Ambient R JA 417 °C/W

P2N2222A Amplifier Transistors - ON Semiconductor

Vdc SMALL−SIGNAL CHARACTERISTICS Current−Gain − Bandwidth Product (Note 2) (IC = 20 mAdc, VCE = 20 Vdc, f = 100 MHz)C fT 300 − MHz Output Capacitance (VCB = 10 Vdc, IE = 0, f = 1.0 MHz) Cobo − 8.0 pF Input Capacitance (VEB = 0.5 Vdc, IC = 0, f = 1.0 MHz) Cibo − 25 pF Input Impedance (IC = 1.0 mAdc, VCE = 10 Vdc, f = 1.0 kHz)