Transcription of Gear Type Flow Meter VC - Process Pump Sales
{{id}} {{{paragraph}}}
Example: barber
Gear Type Flow Meter VC - Process Pump Sales
gear Type Flow MeterVCConstruction and principle of operation1 Housing2 Cover3 Gear4 Preamplifier5 Connector6 Sensor7 Bearing assembly The measuring gears aredriven by the liquid flowon the principle of a gearmotor. The gears run withoutcontact in the measuringchamber. The bearing ele-ments are low-friction ballor plain bearings. The movement of thegears is sampled withoutcontact by means of twosensors located in thecover. Between sensorcompartment and measu-ring chamber is located apressure-resistant, non-magnetic separator plate. 1234675 Principle of operationConstruction When the measuringmechanism rotates by onetooth pitch, the sensoremits a signal which cor-responds to the geometri-cal tooth volume Vgz . The signal is convertedinto a square-wave signalby the preamplifier. The two-channel samplingpermits better resolutionas well as recognition ofthe flow GmbH Postbox 1420/1440 D-58774 Werdohl Phone 0049 (23 92 ) 935-0 Fax 0049 (23 92 ) 935 209 Internet: e-mail: GmbH Postbox 1420/1440 D-58774 Werdohl Phone 0049 (23 92 ) 935-0 Fax 0049 (23 92 ) 935 209 Internet: e-mail: features Optimized for individualapplications because theseries have been renderedmedia-specific by meansof differing clearances,bearing variants andmaterials.
Construction and principle of operation 1 Housing 2 Cover 3 Gear 4 Preamplifier 5 Connector 6 Sensor 7 Bearing assembly • The measuring gears are driven by the liquid flow
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: