Transcription of General Engineering Principles I.
{{id}} {{{paragraph}}}
Example: air traffic controller
General Engineering Principles I.
General Engineering Principles ISealed Source & Device WorkshopGeneral Engineering Principles I: 1 General Engineering Principles IForces:Tensile and Compressive: Tensile (Tension) - pulling apart Compressive (Compression) - pushing together Forces may be direct, or may be caused by changes in pressure, temperature, or combined : Force perpendicular to the primary Source & Device WorkshopGeneral Engineering Principles I: 2 General Engineering Principles IStrength: Stress = Force/Area (psi or Pa) Strain = Elongation under stress =change in length/original length (in /in )length/original length ( ) Ultimate Strength: maximum stress sustained without breaking - exceed this limit and the material will break. Yield Strength: maximum stress sustained without permanent deformation - the material will stretch and come back to its original Source & Device WorkshopGeneral Engineering Principles I: 3 General Engineering Principles IStress vs.
• Hard materials exhibit brittle, catastrophic failure. Therefore, for very hard materials, there ... Excessive presence of sulfur in steel makes it brittle in elevated temperatures. • When the phosphorus contents are too high in ... • Plate - is a rolled product more than 3 0 mmis a rolled product more than 3.0 mm ...
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: