Transcription of GM D1063S Load Cell Strain Gauge Bridge Isol Repeater Is.
{{id}} {{{paragraph}}}
procon Engineering (A Division of National Oilwell Varco UK Ltd) Model D1063S load Cell/ Strain Gauge Bridge Galvanic Isolating Repeater Up to four 350 load cells in parallel or twelve 1000 in parallel EMC compatibility to EN61000-6-2, EN61000-6-4 high accuracy ATEX approved high reliability, SMD components simplified installation using standard DIN rail and plug-in terminal blocks The D1063S acts as transparent and very accurate galvanic isolated interface installed between a weighing indicator/system in the Safe Area and a load cell (or group of load cells ) in a Hazardous Location. The output to the indicator/system is a transparent reflection of a single load cell equivalent to the one/s in the field. The unit located in Hazardous Location repeats with isolation the mV signal output to drive the load in the Safe Area dependent upon the host system reference voltage. Up to four 350 Ohm load cells , or six 400 Ohm load cells , or twelve Ohm load cells can be connected in parallel.
Procon Engineering (A Division of National Oilwell Varco UK Ltd) Model D1063S Load Cell/Strain Gauge Bridge Galvanic Isolating Repeater Up to four 350 Ω load cells in parallel or twelve 1000 Ω in parallel EMC compatibility to EN61000-6-
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}