Transcription of High Voltage Testing - Electrical Engineering
{{id}} {{{paragraph}}}
Example: tourism industry
High Voltage Testing - Electrical Engineering
9 high Voltage Testing high Voltage Testing Procedure Electrical equipment must be capable of withstanding overvoltages during operation. Thus by suitable Testing procedure we must ensure that this is done. high Voltage Testing can be broadly classified into Testing of insulating materials (samples of dielectrics) and tests on completed equipment. The tests carried out on samples of dielectric consist generally of the measurement of permittivity, dielectric loss per unit volume, and the dielectric strength of the material. The first two can be measured using the high Voltage Schering Bridge. The tests carried out on completed equipment are the measurement of capacitance, the power factor or the total dielectric loss, the ultimate breakdown Voltage and the flash-over Voltage . The breakdown Voltage tests on completed equipment is only done on a few samples since it permanently damages and destroys the equipment from further use.
9 High Voltage Testing 9.0 High Voltage Testing Procedure Electrical equipment must be capable of withstanding overvoltages during operation. Thus by suitable testing
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Above 1 kV Insulation Testing A Guide To, Insulation, The Complete Guide to Electrical Insulation Testing, The Complete Guide to Electrical, Table of Contents, Dielectric Absorption, Testing, A Stitch in Time, Electrical, Guide Digital High Voltage Insulation Tester, Guidance-Note on Periodic Inspection and Testing, COMPLETE, Wire