ICC-ES Evaluation Report ESR-3187
ICC-ES Evaluation Report ESR-3187 . Reissued March 2020 . Revised May 2021 . This report is subject to renewal March 2022. www.icc-es.org | (800) 423-6587 | (562) 699-0543 . A Subsidiary of the International Code Council ® DIVISION: 03 00 00—CONCRETE . Section: 03 16 00—Concrete Anchors DIVISION: 05 00 00—METALS
Tags:
International, Code, Report, Evaluation, Council, International code council, Icc es evaluation report
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
ICC-ES Evaluation Report ESR-2269 - Hilti
www.hilti.com1.0 EVALUATION SCOPE Compliance with the following codes: 2018, 2015, and 2012 International Building Code ® (IBC) 2018, 2015, and 2012 International Residential Code® (IRC) For evaluation for compliance with codes adopted by the Los Angeles Department of Building and Safety (LADBS), see ESR-2269 LABC and LARC Supplement.
Report, Evaluation, Hilti, 2269, Icc es evaluation report esr 2269
Page 1/8 Safety Data Sheet acc. to ISO 11014 - Hilti USA
www.hilti.comPage 2/8 Safety Data Sheet acc. to ISO 11014 Printing date 05/19/2015 Version number 5 Reviewed on 05/19/2015 (Contd. of page 1) 40.2.7 H319 Causes serious eye irritation.
Sheet, Data, Safety, Pages, Page 1, Hilti, 8 safety data sheet acc
Hilti. Outperform. Outlast.
www.hilti.comSelector Guide Through-Penetration Joint Reference Data Firestop Mortar (CP 637) Product description ... Concrete and masonry assemblies Expansion on setting (approx.)Walls and floors rated up to 4 hours ... Mix ratio (recommended, mortar to water):
HILTI TECHNICAL BULLETIN
www.hilti.comMar 04, 2018 · )n ≤ 1, where n=5/3 for 3/8- and 1/2-inch diameters (No. 3 and No. 4 rebar) and n=1 for 5/8 and 3/4-inch diameter or No. 5 and No. 6 rebar. 9 The critical spacing, s cr, is the smallest anchor spacing where full load values may be used. The minimum spacing, s min, is the minimum anchor spacing for which values are
HIT-RE 500 V3 - Hilti
www.hilti.comSafety information for 2-Component-products 18/06/2020 US-OSHA - en 2/27 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If skin irritation or rash occurs: Get medical advice/attention. If eye irritation persists: Get medical advice/attention.
Hilti HIT-HY 200 with HIT-V
www.hilti.comAnchor rods HIT-V GR / -HCR) are available in variable length MIO M12 TE 16 M16 M20 M24 TE 40 M27 - TE 70 M30 compressed air gun or blow out pump, set of cleaning brushes, dispenser Drill hole to the required embedment depth with an appropriately sized Hilti TE-CD Or TE-YD hollow drill bit with Hilti vacuum attachment. This drilling
With, Anchor, Rods, Hilti, Anchor rods, Hilti hit hy 200 with hit
Hilti HIT-HY 200 with rebar
www.hilti.comHilti HIT-HY 200 with rebar Benefits - suitable for cracked and non- cracked concrete C 20/25 to C 50/60. - Approved automatic cleaning with the use of the hollow drill-bit high loading capacity, excellent handling HY 200-R version with extended curing time for rebar applications small edge distance and anchor spacing possible
KB-TZ2 TECHNICAL GUIDE
www.hilti.comKB-TZ2 Technical uide April 2021 5 Table 4 - Allowable Hilti carbon steel KB-TZ2 strength in uncracked concrete for hammer drill and core drill installations 1,2,3,4 Nominal anchor
OPENINGS IN COMPOSITE FLOOR DECKS - Hilti
www.hilti.comin-situ reinforced concrete topping. The decking not only acts as a permanent formwork to the concrete, but also provides sufficient shear bond with the concrete so that, when the concrete has cured, the two materials act together compositely to resist the loads on the deck. Openings in floor decks are a common part of any building.
HIT-1 ADHESIVE ANCHORING SYSTEM - Hilti
www.hilti.comHIT-1 ADHESIVE ANCHORING SYSTEM Technical Supplement PRODUCT DESCRIPTION Hilti HIT-1 is a hybrid adhesive mortar combining resin, hardener, cement, and water. It’s formulated for fast curing and easy installation in a wide range of concrete and masonry base materials with temperatures ranging from 32°F (0°C) up to 95°F (35°C).
Related documents
ICC-ES Evaluation Report ESR-3223 - ITW BUILDEX
www.itwbuildex.comICC-ES Evaluation Report ESR-3223 Reissued August 2014 This report is subject to renewal November 1, 2015. www.icc-es.org | (800) 423-6587 | (562) 699-0543 A Subsidiary of the International Code Council ® DIVISION: 05 00 00—METALS Section: 05 05 23—Metal Fastenings REPORT HOLDER: ITW BUILDEX 700 HIGH GROVE BOULEVARD
International, Code, Report, Evaluation, Council, International code council, Icc es evaluation report
ICC-ES Evaluation Report ESR-1900* - Eagle Roofing
www.eagleroofing.comICC-ES Evaluation Report ESR-1900 CBC and CRC Supplement* Reissued February 2014 This report is subject to renewal on March 1, 2016. www.icc-es.org | (800) 423-6587 | (562) 699-0543 A Subsidiary of the International Code Council ® DIVISION: 07 00 00—THERMAL AND MOISTURE PROTECTION Section: 07 32 16—Concrete Roof Tiles REPORT HOLDER: …
International, Code, Report, Evaluation, Council, International code council, Icc es evaluation report
ICC-ES Evaluation Report ESR-1475 - GAF
www.gaf.comICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed as an endorsement of the subject of the report or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as
Report, Evaluation, Es evaluation, Icc evaluation, Icc es evaluation report
ICC-ES Evaluation Report ESR-4561 - Hilti
www.hilti.comICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed , nor are they to be construed as an endorsement of the subject of the report or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as
Report, Evaluation, Hilti, Es evaluation, Icc evaluation, Icc es evaluation report
ICC-ES Legacy Report NER-405* Reissued April 2004
www.jameshardie.comICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed as an endorsement of the subject of the report or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as
ICC-ES Evaluation Report ESR-2290 - James Hardie Pros
www.jameshardiepros.comICC-ES Evaluation Report ESR-2290 . Reissued March 2020 . Revised June 2020 . This report is subject to renewal March 2022. www.icc-es.org | (800) 423-6587 | (562) 699-0543 . A Subsidiary of the International Code Council ® DIVISION: 06 00 00—WOOD, PLASTICS AND COMPOSITES . Section: 06 16 00—Sheathing . DIVISION: 07 00 00—THERMAL AND ...
International, Code, Report, Evaluation, Council, International code council, Icc es evaluation report
UL Evaluation Report - GAF
www.gaf.com2. SCOPE OF EVALUATION 2018, 2015, 2012, 2009, and 2006 International Building Code ® (IBC) 2018, 2015, 2012, 2009, and 2006 International Residential Code ® (IRC) ICC ES Acceptance Criteria for Quality Documentation (AC10), Dated January 2019 The products were evaluated for the following properties:
Seismic Design Specification for Buildings, Structures ...
www-group.slac.stanford.eduprocedures summarized by the manufacturer’s approved ICC-ES/ESR report.4 Additional information on post-installed anchors can be found in Section 4 of this document. 1 The California Building Code (CBC) is codified as Title 24, California Code of Regulations ,
SEISMIC CEILING INSTALLATION
www.armstrongceilings.comICC-ES employs a large staff of professionally licensed architects and civil, structural, mechanical, and fire protection engineers. The members of the ICC-ES technical staff are experts in the application of model codes, and also have access to historical information relating to …
Installation, Seismic, Ceiling, Seismic ceiling installation