Transcription of Installation and Operation Guide Portable Wireless Doorbell
{{id}} {{{paragraph}}}
RDWL917AX2000 Read before installingInstallation and Operation GuidePortable Wireless DoorbellPreparationDoorbell Push ButtonWall AnchorsRound Head ScrewsFlat Head ScrewsPhillips ScrewdriverStandard ScrewdriverDrill and 1/4 in. ( mm) drill bit4 C alkaline batteriesDoorbell Wall Mounting BracketPush Button Mounting Bracket and Adhesive PadTo install you will needIn the box you will findThe push button supplied with this kit is pre-programmed to operate with the Doorbell . If it is not, see Connect a Push Button on page BatteryUSB Cable2 OverviewJust follow these simple steps:1.
• Always follow the manufacturer’s advice when using power tools and wear suitable protective equipment (e.g. safety goggles) when drilling holes, etc. • Before drilling holes in walls, check for hidden electricity cables and water pipes. The use of a cable/pipe locator is advisable if in doubt. Install Batteries 1. Open the battery cover and
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}