Transcription of Installation Instructions for Vinyl Flush Fin …
{{id}} {{{paragraph}}}
Example: air traffic controller
Installation Instructions for Vinyl Flush Fin …
Sealant Gap 6 IF USING FLASHING 1. Seal the top corners of the window with a 1/4" bead of sealant. Tool into a fillet shape. 2. Release the building wrap from above the header (previously taped up) and overlap the header flashing. Seal the ends with self-sealing flashing or building wrap tape. 3. Ensure weep holes/ channels are clear of debris for proper water drainage; do not seal weep holes/channels if present. IS USING FLexIbLe FLASHING Mechanically fasten flashing. Apply sealant down sides where the window meets the flashing. Tool or smooth out the sealant. AFter INStALLAtIoN1. Install exterior wall surface within seven days of window Installation . 2. Maintain gap of 1/4"-3/8" between window frame and final exterior wall surface (siding, stucco, etc.)
Sealant Gap 6 IF USING FLASHING 1. Seal the top corners of the window with a 1/4" bead of sealant. Tool into a fillet shape. 2. Release the building wrap from above the header (previously
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Stucco, ASTM D1784 cell classification 13244C Stucco & Plaster Accessories, SPECIFICATION GUIDE, Sentry Stucco CI Wall System – Section, INSPECTION REPORT Report No, Vinyl, REVEALS & MOLDINGS BROCHURE, General Notes and Architectural Guidelines, THE TRUTH ABOUT VAPOR PERMEABILITY, THE TRUTH ABOUT VAPOR PERMEABILITY IN HIGH HUMIDITY ENVIRONMENTS