Installing remote sites using TCP/IP - Paxton

Installing remote sites using TCP/IPConnecting Net2 via TCP/IP networksNet2 supports the connection of control units to the Net2 server over RS485 data lines and also via nodes on TCP/IP Ethernet networks. This greatly increases the flexibility of installation diagram shows a Net2 system communicating over a LAN network using a Net2 plus ACU that combines a converter with a door controller. This requires software or plus Net2 plus TCP/IP LAN/WANRS485 data line RS485 data line PC running full Net2 software with serverAPN-1006 Net212 APN-1006 Net2Up to 200 control units can be connected to the RS485 data line. This data line must be terminated with 120 ohm resistors switched or wired across both data pairs at each interface unit may be located at any position along the RS485 data Net2 server PC can communicate with its' door controllers over the users network via a LAN, WAN or VPN Net2 plus control unit plugs directly into a standard TCP/IP network connection.

Paxton Net2 plus. r 1 e ad. n: o ti u a C. y nl o s r ade e C r D V 2 or 1 2 r e d Rea V D D D /D0 k/D1 R D D D /D0 1 t V N.C. N.O. COM N.C. N.O. u O r P Contact 0V 0V Tamper PSU er p PSU/Tam Contact on y 2 a 1 ay Rel Expansion r G / t W p r o n r c S a m r f s c l b a G g O / t h W e g n a O 10/100 Ethernet nk 0 End of Line Termination ON OFF ...

Loading..

Tags:

  Using, Site, Remote, Paxton, Installing, Installing remote sites using tcp

Information

Related search queries