Transcription of Instrumentation and Control - Energy
{{id}} {{{paragraph}}}
Example: bachelor of science
Instrumentation and Control - Energy
Instrumentation and Control Qualification Standard DOE-STD-1162-2013 June 2013 Reference Guide The Functional Area Qualification Standard References Guides are developed to assist operators, maintenance personnel, and the technical staff in the acquisition of technical competence and qualification within the Technical Qualification Program (TQP). Please direct your questions or comments related to this document to the Office of Leadership and Career Management, TQP Manager, NNSA Albuquerque Complex. This page is intentionally blank. Table of Contents FIGURES .. iii TABLES .. v VIDEOS .. v ACRONYMS .. vii PURPOSE .. 1 SCOPE .. 1 PREFACE .. 1 1. Instrumentation and Control (I&C) personnel must demonstrate a familiarity level knowledge of basic electrical engineering fundamentals.. 2 2. I&C personnel must demonstrate a familiarity level knowledge of basic mechanical engineering fundamentals, including thermodynamics and hydraulics.
Figure 7. Simple ladder diagram 24 Figure 8. Sample circuit 25 Figure 9. Relay logic circuit 25 Figure 10. Continuous circuit 26 Figure 11. Ladder diagram for a load device 27 Figure 12. Short circuit 27 Figure 13. Corrected ground fault 28 Figure 14. Electrical signal analysis 29 Figure 15. Gate valve 34 Figure 16. Relief valve 36 Figure 17.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: