INSULATED ROOFING,

For Cooldek roofi ng in attached or freestanding domestic gable patio application, sheet spans shall not exceed those given for one or no open sides. Alternatively, Table 3.0 indicating wind capacities may be used to determine allowable single spans for any application. Spans specifi ed for units with three sides open are suitable for

  Patio, Attached

STRATCO FRONTIER ASSEMBLY INSTRUCTIONS.

7.0BARGECAPPING Only the front and two sides of the carport require the attachment of barge capping. The rear has the gutter attached. Fix the side barge capping first.

Purlins & Girts - stratco.com.au

1 The Stratco Capacity Tables have been calculated in accordance with limit state design principles and comply with the Australian/ New Zealand Standard AS/NZS 4600:2005 Cold-formed steel

  Design

Cooldek Outback Flat Attached Installation Guide

It is the builder’s responsibility to ensure any existing structure that an Outback is being attached to is adequately reinforced to accommodate the additional loads imposed by the verandah, patio or carport. Read these instructions thoroughly before starting your project and refer to them constantly during each stage of construction.

  Patio, Attached

OVERFLOW SOLUTIONS - Stratco

system (who may be the architect, builder, hydraulic engineer, home owner, roofing or guttering contractor) to design a ... The following overflow solutions provide a measure for continuous overflow for the full length in which the solution is applied.

  Solutions, Architect

POST & RAIL FENCING 1300 155 155 SCAN THIS QR CODE TO …

Stratco Post & Rail fencing is a traditional and cost e˜ ective form of fencing. Its simple design makes it the ideal choice for a ... Fence capping is placed over the top edge of the fence sheet with the long side of the capping facing the post and rail side of the fence. The capping is slightly tapered to allow for overlapping.

  Edges, Ective

Roller Door - Stratco

door to be installed and if the headroom is a restricted space. • If the roller door is installed with a headroom greater then those listed in the Headroom Measurements table, the resulting daylight opening will be reduced. • If the roller door is installed significantly below the top of the

  Doors, Roller, Roller door

Fencing Frameless Glass Catalogue - Sheds | Fencing | Roofing

12mm Fully Frameless Glass flat polished edges 5mm radius corners 01 Stratco Order Code G.O. Order Code Width Sqm Corner Radius Glass Weight KGS ... base plate - 10mm thick 95mm 73mm inner hole diameter 12mm 95mm 73mm 26 11 100 187 127 95 NOT TO SCALE 60 NOT TO SCALE 21 239 111 52 128 52 • Stainless Steel 2205

  Glass, Plate, Fencing

WIND CLASSIFICATION, - Stratco

N1 (Non-Cyclonic) N/A W28 N2 (Non-Cyclonic) N/A W33 N3 (Non-Cyclonic) C1 (Cyclonic) W41 N4 (Non-Cyclonic) C2 (Cyclonic) W50 N5 (Non-Cyclonic) C3 (Cyclonic) W60 N6 (Non-Cyclonic) C4 (Cyclonic) W70 TERRAIN CATEGORY The wind speed at a structure is infl uenced by the terrain it fl ows over as it approaches the structure. The terrain category

  Cyclonic

SUPERDEK - Stratco

Roofing calculations are based on Cpe=-0.9 and Cpi=0.2, walling is based on Cpe=-0.65 and Cpi=0.2. A local pressure factor, Kl=2.0 has been used for all roofing spans for both strength and serviceability limit states. Roof spans take into consideration loads incidental to maintenance. All pressures have been determined assuming wind

  Limits, Calculation

Sheet 26001 Power Circuit Breakers Insulated-Case ... - Eaton

Insulated-Case Circuit Breakers, and Molded-Case Circuit Breakers There are main classifications of low- ... (UL 67), MCCs (UL 845), control panels (UL 508) and NEMA rated enclosures Closing speed 3-cycle closing for electrically operated devices 3-cycle closing for electrically operated devices Greater than 5-cycle closing for electrically

  Eaton, Panels, Insulated

Board & Batten - CertainTeed

Board & Batten panels have a thickness of .048" for strength and durability. Super-Premium .052" Thickness Board & Batten panels have a thickness of .052" for strength and durability. CedarBoards™ Insulated Board & Batten Rough Cedar Finish CertainTeed was the first to utilize a direct transfer system from real cedar boards

  Board, Panels, Insulated, Certainteed, Batten, Board amp batten, Board amp batten panels, Insulated board amp batten

Window Styles - Wayne Dalton

Colonial, Ranch and Contemporary panels. Windows placed in the bottom section of a door must use DSB 1/8", tempered, or 1/2" insulated glass. **All window option only available on Model 8300. Contemporary/Flush panels with Clear I or Clear III windows. Place order as ThermoMark™ Model 5150.

  Panels, Insulated

9100/9605 - Wayne Dalton

*Wayne Dalton uses a calculated door section R-value for our insulated doors. †R-value of 10 for 8’ tall doors. R-value for other door heights may vary slightly. See website for warranty and wind load details. Pinch-Resistant Panels designed to push fingers out of harms way. 3-layer construction Model 9100 utilizes a ToughGard®

  Panels, Insulated, 5069, 9100, 9100 9605

Prepared by PCI Committee on Precast Sandwich Wall Panels

The panels are fabricated at a precast concrete manufacturing plant, shipped to the project site, and erected by cranes. Panels generally span vertically between foundations and floors or roofs to provide the permanent wall system but may also span horizontally between columns. In this report, precast/prestressed concrete sandwich wall panels

  Panels

TEXTURE AND COLOR GLASS OPTIONS FOR INSULATED …

* Texture located inside insulated unit to protect against finger marks. † Beveled glass is positioned on the opposite side of the IG unit from the example above, ensuring a better fit. † Beveled glass is positioned on the opposite side of the IG Arrow indicates the surface where the texture is located.

  Insulated

The History of Solar - Energy

with copper coils and an insulated box—roughly, it’s present design. 1914 The existence of a barrier layer in photovoltaic devices was noted. 1918 Polish scientist Jan Czochralski developed a way to grow single-crystal silicon. For more information on Czochralski, see the article

  Energy, Solar, Insulated

Thermacore - Overhead Door

Windows placed in the bottom section of a door must have DSB 1/8", tempered, or 1/2" insulated glass. Model 5740, Flush panel, Gray finish, Clear Long windows Vertical window option All window option (Flush panel only) Actual glass may vary from brochure photos due to fluctuations in the printing process.

  Doors, Insulated, Overhead, Mothercare, Overhead door