Transcription of ISO 15693 Protocol Guide - metraTec
{{id}} {{{paragraph}}}
Example: quiz answers
ISO 15693 Protocol Guide - metraTec
ISO 15693 Protocol Guidefor metraTec RFID Readers and ModulesDate: Mai 2013 Version: Firmware Version: ISO 15693 Protocol Guide Page 1 of 37 1 Table of Content 1 Table of Further Communication Helpful Reader Control Reset (RST).. Revision (REV).. Read Serial Number (RSN).. Read Hardware Revision (RHR).. Standby (STB).. Wake Up (WAK).. Read Input Pin (RIP).. Write Output Pin (WOP).. Start Up Commands (SUC).. Mode (MOD) .. Set RF Interface (SRI).. Set Timings (STT).. Cyclic Redundancy Check On (CON).. Cyclic Redundancy Check Off (COF).. End of Frame Mode (EOF).. No End of Frame Mode (NEF).
1. Introduction This document describes the metraTec firmware protocol for all metraTec RFID readers that work with RFID transponders according to ISO 15693.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
136 SystemVerilog Assertions Handbook, AVR Assembler, AVR Assembler AVR Assembler, AVR® Assembler, Challenges and opportunities for LTE Network, Challenges and opportunities for LTE Network Management, Protocol6, Direct Protocol 6, Direct Protocol, C++ Essentials, Effective Investigation Reports . . . Tips to Writing