PDF4PRO ⚡AMP

Modern search engine that looking for books and documents around the web

Example: biology

Lab – Configuring IPv4 Static and Default Routes (Solution ...

2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 16 Lab Configuring IPv4 Static and Default Routes (Solution) Topology Addressing Table Device Interface IP Address Subnet Mask Default Gateway R1 G0/1 N/A S0/0/1 N/A R3 G0/1 N/A S0/0/0 (DCE) N/A Lo0 N/A Lo1 N/A PC-A NIC PC-C NIC Objectives Part 1: Set Up the Topology and Initialize Devices Lab Configuring IPv4 Static and Default Routes 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.

recursive static routes, use the following syntax: Router(config)# ip route network-address subnet-mask ip-address a. On the R1 router, configure a static route to the 192.168.1.0 network using the IP address of the Serial 0/0/0 interface of R3 as the next-hop address. Write the command you used in the space provided.

Loading..

Tags:

  Route, Static, Static routes

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Spam in document Broken preview Other abuse

Transcription of Lab – Configuring IPv4 Static and Default Routes (Solution ...

Related search queries