Transcription of LABORATORY SAFETY DESIGN GUIDE - EHS
{{id}} {{{paragraph}}}
Example: marketing
LABORATORY SAFETY DESIGN GUIDE - EHS
LABORATORY SAFETY DESIGN GUIDE 2014 EH&S LABORATORY SAFETY DESIGN GUIDE Revised July 2014 Page 2 of 74 TABLE OF CONTENTS Section 1 General Requirements for Laboratories Section 2 Environmental Requirements Section 3 LABORATORY Ventilation Section 4 Emergency Eyewash and SAFETY Shower Equipment Section 5 Compressed Gas and Cryogenic Components and Systems Section 6 Hazardous Materials Storage Cabinets Section 7 Biosafety Laboratories Section 8 Fire SAFETY Section 9 Additional Requirements for Radioactive Materials Laboratories Section 10 Additional Requirements for Laboratories with Irradiators and/or Radiation Producing Machines Section 11 Additional Requirements for Laboratories Using Non-Ionizing Radiation Sources Appendix A Additional Fume Hood Exhaust Criteria for Facilities Not Owned by the University of Washington Appendix B General Hazardous Materials Provisions Appendix C LABORATORY Decommissioning EH&S LABORATORY SAFETY DESIGN GUIDE Revised July 2014 Page 3 of 74 INTRODUCTION The construction of LABORATORY facilities requires oversight.
electrical, plumbing, and other considerations should be completely and permanently sealed. If the bench top abuts a wall, it should be covered or have a backsplash against the wall. 7. The walls shall be non-porous and painted with a durable, impervious finish to facilitate decontamination and cleaning. High gloss paint is recommended. 8.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: