Transcription of Lathe Programming Workbook - Haas Automation
{{id}} {{{paragraph}}}
Example: bankruptcy
Lathe Programming Workbook - Haas Automation
WORKBOOKPROGRAMMINGHAAS Automation , STURGIS ROADOXNARD, CA Automation , Automation , SERIESLATHE SERIESI Programming ST/TLST/TLHAAS Automation Sturgis RoadOxnard, California 93030 Phone: Workbook is for the exclusive use of Haas Automation technicians, distributors, educators, and customers. Any reproduction, transmission, or use of this Workbook or its contents for profi t is prohibited. You may reproduce this Workbook without written consent for educational purposes. This training information is provided at no cost to all Haas customers and schools currently training with Haas equipment. Modifi cation of this Workbook is restricted without written consent from Haas Automation , subject matter in this Workbook may change without notice. You can scan the QR code below with your mobile device, or go to to access the most current 2015, Haas AutomationII PROGRAMMINGST/TLST/TLCUSTOMER SATISFACTION POLICYDear Haas Customer,Your complete satisfaction is of the utmost importance to both Haas Automation , Inc.
on the lathe. This view shows the X and Z axes as the operator faces the lathe. Note that at the intersection of the two lines, a common zero point is established. The four areas to the sides and above and below the lines are called “QUADRANTS” and make up the basis for what is known as rectangular coordinate programming.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: