Transcription of LC Filter Design (Rev. A) - Texas Instruments
{{id}} {{{paragraph}}}
Example: bankruptcy
LC Filter Design (Rev. A) - Texas Instruments
1 SLAA701A October2016 RevisedNovember2016 SubmitDocumentationFeedbackCopyright 2016,TexasInstrumentsIncorporatedLC FilterDesignAll trademarksare the propertyof October2016 RevisedNovember2016LC FilterDesignABSTRACTIn higher-powerclass-Damplifiers,generallya bove10 W of outputpower,a filteron the outputof theamplifieris filteris passivein natureand usesbothan inductorand a capacitoron ,it is referredto as an LC the LC filteriscriticalto meetthe desiredaudioperformance,efficiency,EMC/E MIrequirements,and costfor the a guideto aid in the sectionof LC filtercomponentsforclass-Damplifiersto meettarget-designgoalsof the end (BTL).. (PBTL).. (SE).. (Traditional) OutputLC AD ModulationWithType-1or Resistance(DCR).. of Figures1 Stereo(Two-Channel)BTL (Traditional) October2016 RevisedNovember2016 SubmitDocumentationFeedbackCopyright 2016,TexasInstrumentsIncorporatedLC FilterDesign6 Effectof Q on AD FilterResponseWithCBTL= F and LBTL= 10 BD or AD FilterResponseWithCg= F and LBTL= 10 AD FilterResponseWithCBTL= F, Cg= F, and LBTL= 10 ModulationFilterConvertedto +Nvs OutputPower,4.
The filter is passive in nature and uses both an inductor and a capacitor on each output terminal. Therefore, it is referred to as an LC filter. Proper component selection of the LC filter is ... 13 Film-Capacitor Key Parameters ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: