Transcription of LOAD AND RESISTANCE FACTOR DESIGN SPECIFICATION
{{id}} {{{paragraph}}}
Example: confidence
LOAD AND RESISTANCE FACTOR DESIGN SPECIFICATION
LOAD AND RESISTANCEFACTOR DESIGNSPECIFICATIONFor StructuralSteel BuildingsDecember 27, 1999 Load andResistanceFactor DesignSpecificationfor Structural Steel BuildingsDecember 27, 1999 Supersedes theLoad and RESISTANCE FACTOR DESIGN Specificationfor Structural Steel BuildingsdatedDecember 1, 1993 and all previous by theAmerican Institute of Steel Construction, the Direction of theAISC Committee on Specifications and approved bythe AISC Board of INSTITUTE OF STEEL CONSTRUCTION, East Wacker Drive, Suite 3100 Chicago, Illinois 60601-2001 with errata incorporated as of September 4, 2001 Copyright 2000byAmerican Institute of Steel Construction, rights reserved. This book or any part thereof must not be reproduced in anyform without the written permission of the information presented in this publication has been prepared in accordance withrecognized engineering principles and is for general information only. While it isbelieved to be accurate, this information should not be used or relied upon for anyspecific application without competent professional examination and verification ofits accuracy, suitability, and applicability by a licensed engineer, architect or otherprofessional.
•Reorganization of material on pin-connected members and eyebars. •Revised provisions for concrete-encased beams. •New limitation on the stud reduction factor when a …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: