Transcription of Mallory Unilite Distributor Installation Instructions
{{id}} {{{paragraph}}}
Unilite DISTRIBUTORThis product is applicable to pre-1966 California and pre-1968 federally certified passenger cars. It is also applicable to non-emission controlled trucks and similar vehicles. It is not applicable or intended for use on any emission controlled vehicles operated on highways or roads, unless otherwise INSTRUCTIONSFORM 1214M (REV. K) 05/13 GENERAL INFORMATIONA dvance Curve:Most Unilite Distributors with part numbers that end in 01 have 24 (crankshaft degrees) of mechanical advance (between 3,000 and 3,200 RPM). Listed below are exceptions: CHEVY LUV ..28 AT 3,000 RPM CHEVY VEGA.
harness small green and black magnetic pickup wires not used refer to ignition control instructions for remaining power connections part nos. 600, 610, 629, 630, 631, 685, 692, or 697 distributor wire harness part no. 29349 12v/ignition switch ignition ballast resistor ring terminal connectors part no. 450 ignition module female connector green ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}