Transcription of Manual - Curtis Instruments
{{id}} {{{paragraph}}}
ManualElectronic Motor Controllers Read Instructions Carefully!Specifications are subject to change without notice. 2019 Curtis Instruments , Inc. Curtis is a registered trademark of Curtis Instruments , Inc. The design and appearance of the products depicted herein are the copyright of Curtis Instruments , Inc. 53112 Rev F Sep 2019 Curtis Instruments , Kisco AvenueMt. Kisco, NY 1212 & 1212P1212 & 1212P Manual - Sep 2019pg. iiTABLE OF CONTENTSCHAPTERS1: OVERVIEW ..12: installation AND WIRING ..4 MOUNTING THE CONTROLLER ..4 CONNECTIONS: HIGH CURRENT ..5 CONNECTIONS: LOW CURRENT ..5 WIRING: STANDARD installation , 1212 ..6 WIRING: STANDARD installation , 1212P ..7 THROTTLE WIRING ..8 SWITCHES AND OTHER HARDWARE.
WIRING: STANDARD INSTALLATION, 1212 The wiring diagram presented in Figure 3a shows a typical installation for a DME application. This installation is shown with a single-ended 3-wire 5k potentiometer throttle and a reverse switch. Ω With wigwag throttles, a reverse switch is not used and Pin J1-12 is left unconnected.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}