Transcription of Manual for Design and Detailing of Reinforced Concrete to ...
{{id}} {{{paragraph}}}
Manual for Design and Detailing of Reinforced Concrete to the Code of Practice for Structural Use of Concrete 2013 September 2013 September 2013 Manual for Design and Detailing of Reinforced Concrete to the Code of Practice for Structural Use of Concrete 2013 Contents Introduction Some highlighted aspects in Basis of Design Beams Slabs Columns Beam-Column Joints Walls Corbels Cantilevers Transfer Structures Footings Pile Caps General Detailing Design against Robustness Shrinkage and Creep Appendices 1 September 2013 Manual for Design and Detailing of Reinforced Concrete to the Code of Practice for Structural Use of Concrete 2013 Introduction Promulgation of the Revised Code The revised Concrete code titled Code of Practice for Structural Use of Concrete 2013 was formally promulgated by the Buildings Department of Hong Kong in end February 2013 which supersedes the former Concrete code 2004.
The small notional horizontal load can generally be covered by wind loads if wind loads are applied to the structure. Identification of key elements and designed for ultimate loads of 34 kPa, together with examination for ... It can readily be seen …
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}