Transcription of Manual of Standard Practice - CRSI
{{id}} {{{paragraph}}}
ContentsPreface iChapter 1 Material Specifications for Reinforcing Bars Introduction Reinforcing Bars ACI 318 Code Requirements for 1-1 Reinforcing Specialty Reinforcing Bars Spiral Reinforcement Standard Sizes Material Welding of Reinforcing Bars Material Specifications and Welding Code Project Drawings and Project Specifications CRSI Recommendations Identification Marks 1-5 ASTM Standard Reinforcing BarsChapter 2 Welded Wire Reinforcement (WWR) Introduction ASTM Specifications WWR Style Identification Specifying Welded Wire Reinforcement Detailing Welded Wire Reinforcement Width Length ASTM Specification for Epoxy-Coated Wire 2-2 and Welded Wire Reinforcement ASTM Specification for Zinc-Coated (Galvanized) 2-2 Steel Welded Wire ASTM Specification for Stainless-Steel 2-2 Welded Wire Rust Handling, Shipping and Unloading 2-3 Chapter 3 Supports for Reinforcement (Bar Supports) Introduction Side-Form Spacers Recommendations for Bar Supports Standard , Non-Coated Epoxy-Coated or Dual-Coated
4.10 Flat Plates and Flat Slabs 4-3 4.11 Post-Tensioned Beams and Slabs 4-4 4.12 Falsework and Form Reuse 4-4 4.13 Columns 4-4 4.14 Structural Integrity 4-4 4.14.1 Joists 4-4 4.14.2 Beams 4-5 4.14.3 Two-Way Slabs 4-5 4.15 Splices 4-5 4.16 Designing with Specialty Reinforcing Bars 4-5 4.17 Fabrication of Reinforcing Bars 4-5
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}