Transcription of MATERIALS SELECTION FOR WET CYLINDER LINER
{{id}} {{{paragraph}}}
Example: dental hygienist
MATERIALS SELECTION FOR WET CYLINDER LINER
IOSR Journal of Engineering (IOSRJEN) e-ISSN: 2250-3021, p-ISSN: 2278-8719, Volume 2, Issue 9 (September 2012), PP 23-32 23 | P a g e MATERIALS SELECTION FOR WET CYLINDER LINER Ahmad Fakaruddin1, A. Mohd Hafiz1 and *,2 1 Department of Mechanical Engineering, Polytechnic of Sultan Azlan Shah, 35950 Behrang, Perak, Malaysia 2 Department of Environmental and Occupational Health, Faculty of Medicine and Health Sciences, Universiti Putra Malaysia, 43400 UPM Serdang, Selangor, Malaysia Abstract Introduction: CYLINDER LINER is used in engine block to give a wear protective surface for piston and piston rings. Problem statement: However, continuous exposure to high pressure, high temperature, vibration and friction inside combustion chamber could damage and reduce CYLINDER LINER efficiency. Objective: Therefore, the purpose of this study is to find a suitable material for CYLINDER LINER that can withstand the stated constraints.
Materials Selection For Wet Cylinder Liner www.iosrjen.org 25 | P a g e Design Approach The suitable material for the application of cylinder liner should withstand few important constraints such as:
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: