MP1-setup CZ EN DE - MTB model

MP1 model railway motor switchThe motor switch is used for electric operation of the two-position mechanisms in models, such as turnout points or mechanical signals and barriers. Thetravel distance can be setin three steps,3 mm,6mmand 9mm see the illustrationBoth and power supplies are suitable, with a current consumption aprox 150 mA during motion. The mechanism has a end of travel detectionswitch, the control voltage can be applied permanently, to be disconnected automatically once a respective position is reached and the motion accessory and frog control purposes, there is a 1-amp switch SPDT contact with ressetable thermal protection fuse set to protectionon the point to the COM+ terminal with powersupply. The F1 contact will close once themovement ends up at the Position 1 (or the Position2 in case ofthe F2contact respectively)How to change the distance of travelAstepsA)Unscrew 3 screws on the housing bottomB)Remove the slider assemblyC) Setthe pin toa desired positionD) Reassemble the setand fitthe housing.

MotorickýpøestavníkpromodelovouelezniciMP1 Pøestavník slouí pro elektrické ovládání dvoupolohových mechanismù v modelech, typicky výhybky èi mechanická ...

Loading..

Tags:

  Setup, Mp1 setup cz en de

Information