Transcription of MPFI FUEL INJECTION SYSTEM - Holley
{{id}} {{{paragraph}}}
Example: biology
MPFI FUEL INJECTION SYSTEM - Holley
1 MPFI FUEL INJECTION SYSTEM PART NUMBERS 550-903 thru 905, 550-916 thru 918 & 550-926 thru 931 INSTALLATION & TUNING MANUAL 199R11760 2 NOTE: These instructions must be read and fully understood before beginning installation. If this manual is not fully understood, installation should not be attempted. Failure to follow these instructions, including the pictures may result in subsequent SYSTEM failure. TABLE OF CONTENTS: INTRODUCTION .. 3 WARNINGS, NOTES, AND NOTICES .. 3 PARTS IDENTIFICATION .. 4 ADDITIONAL ITEMS REQUIRED FOR INSTALLATION.
response. If you have long tube headers, mount the sensor approximately 1-10” after the collector. You must have no less than 18 – 24” of exhaust pipe after the sensor. TERMINATOR X™ EFI systems come with a Bosch LSU 4.9 wideband oxygen sensor (Item 11). Make sure your sensor looks like Figure 5. Figure 5 Fuel Rail
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: