Transcription of MS 28774 - Pressure Seal
{{id}} {{{paragraph}}}
Example: stock market
MS 28774 - Pressure Seal
MS 28774 Back-up, Single Turn Notes: 1. Surfaces must be smooth and free from irregularities. Edges must be clean and sharp. 2. Dimensions are in inches. 3. For use in packing grooves conforming to MIL-G-5514 and MIL-P-5514. 4. When measuring dimension M over a mandrel ( M dimension +.001), the maximum gap shall not be exceeded and no overlap is permitted beyond the full scarf. 5. For Dash Sizes 140-149, 231-247, 438-460, it is recommended that the respective Dash Sizes under MS 27595 (not cut) be used when possible. 6. For extended sizes cut back-up rings see TF74C. 7. Material: Tetrafluoroethylene MIL-R-8791. Dash M Dash M No. Dia. Tol. T W G No. Dia. Tol. T W G 004 120 005 121 006 122 007 123 008 124 009 125 010 126 011 127 012 128 013 129 014 130 015
MS 28774 Back-up, Single Turn Notes: 1. Surfaces must be smooth and free from irregularities. Edges must be clean and sharp. 2. Dimensions are in inches.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: