Transcription of NCMA TEK
{{id}} {{{paragraph}}}
Example: confidence
NCMA TEK
ncma TEK. National Concrete Masonry Association an information series from the national authority on concrete masonry technology CRACK CONTROL FOR CONCRETE BRICK AND TEK 10-4. Movement Control (2001). OTHER CONCRETE MASONRY VENEERS. brick units or half-high concrete masonry units, as shown Keywords: concrete brick, control joints, crack control, joint reinforcement, shrinkage, veneer in Figure 1. Concrete brick units most commonly have a nominal thickness of 4 in. (102 mm), lengths of 8, 10, 12 or 16 in. (203, 254, 305 or 406 mm) and heights from 2 1/2 to 6 in. INTRODUCTION (64 to 152 mm).
Recommended control joint locations and located where stress concentrations are likely to cause cracks. The joints allow unrestrained longitudinal movement,
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: