PDF4PRO ⚡AMP

Modern search engine that looking for books and documents around the web

Example: marketing

NX-8E Control Panel Installation Manual

P/N I-NX8E-IM REV C ISS NOV12 NX-8E Control Panel Installation Manual Copyright 2012 UTC Fire & Security Americas Corporation, Inc. Interlogix is part of UTC Climate Controls & Security, a unit of United Technologies Corporation. All rights reserved. This document may not be copied in w hole or in part or otherw ise reproduced w ithout prior w ritten consent f rom UTC Fire & Security except w here specifically permitted under US and international copyright law . Disclaim er The inf ormation in this document is subject to change w ithout notice.

6 NX-8E Control Panel Installation Manual Terminal Description RELAY2 C = Closed dry contact rated 1 amp at 30 volts. NO = Normally open dry contact rated 1 amp at 30 volts. Note: These terminals can be set for 12 VDC. Install J12 for AUX1 and J13 for AUX2. COM Common used to ground any devices connected to relays

Fullscreen Download
Loading..

Tags:

  Control, Panels, Control panels

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Spam in document Broken preview Other abuse

Transcription of NX-8E Control Panel Installation Manual

Documents from same domain

NX-8V2 Control Panel Installation Manual

static.interlogix.com

LED keypad programming 11 Control panel programming 14 ... overview of the product and detailed instructions explaining how to install the NX- ... 1 A maximum load. A 3.3 kohm resistor is required across the bell terminals when a 12 VDC siren is used. If no resistor is used, you may experience voltage leakage into the

  Installation, Instructions, Load

TruVision NVR 10 User Manual - Interlogix

static.interlogix.com

• TruVision NVR 10 User Manual (on CD) • TruVision Recorder Operator Guide (on CD) Back panel The figures below show the back panel connections and describe each connector on a typical NVR 10 digital video recorder. Details may vary for specific models. Before powering up the recorder, connect the cameras and a main monitor for basic operation.

  User, Video, Digital, Recorder, Digital video recorder

Concord 4 Installation Manual - Interlogix

static.interlogix.com

Total system power and wire length guidelines The panel can supply up to 1 amp (1,000 mA) in full load alarm condition for system devices connected to panel terminals 4 (+12V), 7 and 8 (speaker terminals), 9 (OUT1), 11 (+12V), 24 (2W SMK ZONE 8), and SnapCard terminals. For 24-hour backup, the total standby current draw for all devices connected to

  Power, Standby, Concord

SuperBus 2000 2X16 LCD Alphanumeric Touchpad …

static.interlogix.com

SuperBus 2000 2X16 LCD Alphanumeric Touchpad Installation Instructions . Product summary . The SuperBus ® 2000 2x16 LCD (liquid crystal display) Alphanumeric Touchpad lets you control all programming and

  Installation, Instructions, Installation instructions

Concord 4 Installation Manual - Interlogix

static.interlogix.com

Siren driver Output that can drive an 8-ohm load and provides intrusion and fire alarm sounds for partition 1 (15 watts maximum). Two onboard outputs Can be used to activate other signaling devices based on system events. Out 1 is a 9 to 14 VDC source output, limited to 1.0 amp max.

  Fire, Lamar, Fire alarm, Concord, Concord 4

TruVision IP Camera Configuration Manual - Interlogix

static.interlogix.com

1BChapter 2: Camera operation 12 TruVision IP Camera Configuration Manual . Configuring network settings . Accessing the camera through a network requires that you define certain network settings. Use the “Network” folder to define the network settings. See Figure 5 and Table 4 below for further information.

  Camera

Related documents

MS-9200UDLS(E) Rev 3 - Fire Alarm Control Panels

www.firelite.com

programming of the control panel using the PS-Tools Upload/ Download utility. In addition, the control panel may be pro- ... ACM-8RF: Relay module provides 8 Form-C 5.0 amp relays. ACS-LED Zone Series: LED-type fire annunciators capable of providing up to 99 software zones of annunciation. Available in

  Control, Early, Panels, Control panels

Features

www.pottersignal.com

Two Relay Two Input module provides two form C relays that are individually controlled by the control panel. Each relay is rated for 2 amps at 30VDC or 0.5 amps at 125VAC. Also provides two contact inputs. PAD100-NAC Notification Appliance Circuit module is an addressable remote appliance circuit controlled by the panel.

  Control, Early, Panels, Control panels

S3 Series Control Panel - Gamewell-FCI

www.gamewell-fci.com

LED Switch Control ANU-48 LED Display Driver RS485 DACT RS232 Ethernet Relay: 3 Form C S3 Series Fire Alarm Control Panel MCS-COF Fire/Carbon Monoxide Detector MS-7AF Pull Station AMM-2RIF Dual Input/Output Module Supports up to 636 Velociti devices or 252 XP95 devices DNR Intelligent Duct Detector ASD-PL2F Photo Detector AOM-2RF Relay Module ...

  Control, Early, Panels, Control panels

Honeywell Home; VISTA-20P; VISTA® Control Panel; Resideo

library.ademconet.com

with four amp hour battery • 16.5 VAC/25 VA transformer • Alarm output 12 VDC, 2.0 amps max. - For UL installations, combined aux. and alarm output cannot exceed 700mA OUTPUT CONTROL • Supports up to four relay boards (up to 16 relays) • Optional X-10 transformer/interface (part no. 4300) may be used to control up to 16 X-10 receiving ...

  Control, Early, Panels, Control panels

NX-8V2 Control Panel Installation Manual

static.interlogix.com

2 NX-8V2 Control Panel Installation Manual Product overview The NX-8V2 Control Panel is a residential security and alarm system and provides the following features: • Sophisticated software allowing up to 99 users to interface with up to 48 zones and eight partitions. • Integrated fire and input/output modules.

  Control, Panels, Control panels

Model 5208 Fire Alarm Control Panel with Digital …

www.silentknight.com

Fire Alarm Control Panel with Digital Communicator The SK-5208 is a microprocessor based control panel with built-in UL listed communicator designed for applications requiring smoke detection, manual pull stations, and sprinkler supervision. It features an easy to read LCD display with programmable English readout and user friendly tactile keys.

  Control, Panels, Control panels

Sewage Lift Station Electrical Specifications

ehrwsd.org

outlet of 120-volt, AC, 20-amp rating. This outlet shall be supplied from the control transformer and shall have GFCI circuit protection. The outlet shall be located in the motor control panel behind the inner door. All enclosures, panels, etc., (including the motor control panel) shall be UL-listed and shall be fabricated by a UL-approved shop ...

  Control, Panels, Control panels

FL-PS6(C) & FL-PS10(C) - Fire Alarm Control Panels

www.firelite.com

PS6(C) is a 6 amp and the FL-PS10(C) is a 10 amp, remote power supply with battery charger that may be connected to any 12 or 24 volt fire alarm control panel (FACP) or used as a standalone power supply. The PS Series provides 24 VDC power for NACs (notifica-tion appliance circuits) configured as either Class B or Class A

  Control, Panels, Control panels, Sp10, Fl ps6, Amp fl ps10

Turbo Cell Control Electronics

www.haywardnet.com

Plugs for S&D control module, base antenna and CL module. Plug for the local display. Auxiliary relays plug (top = Filter, Lights, A1 and A2) (bottom= A3-A6) Four amp fuse protects actuator circuit Valves 1-4 harness plugs for actuators Heater 1 and 2 terminal block to the rectifiers. Temperature sensor / external input terminal block. Remote ...

  Control

Wiring the control box into the vehicle

www.dakotadigital.com

Failure to properly ground the engine block or the control box can cause incorrect or erratic operation. 12 VDC CONSTANT Connect the 12 VDC CONSTANT terminal to a +12V power from the fuse panel that is “hot” all of the time, or a fused wire (5-20 amp) direct to battery power. This terminal should have power all of the time.

  Control, Panels

Related search queries

Control, Control panel, Relay, Panel, FL-PS6(C) & FL-PS10C