Transcription of NX-8E Control Panel Installation Manual - Interlogix
{{id}} {{{paragraph}}}
P/N I-NX8E-IM REV C ISS NOV12 NX-8E Control Panel Installation Manual Copyright 2012 UTC Fire & Security Americas Corporation, Inc. Interlogix is part of UTC Climate Controls & Security, a unit of United Technologies Corporation. All rights reserved. This document may not be copied in w hole or in part or otherw ise reproduced w ithout prior w ritten consent f rom UTC Fire & Security except w here specifically permitted under US and international copyright law . Disclaim er The inf ormation in this document is subject to change w ithout notice. UTC Fire & Security assumes no responsibility f or inaccuracies or omissions and specif ically disclaims any liabilities, losses, or risks, personal or otherw ise, incurred as a consequence, directly or indirectly, of the use or application of any of the contents of this document.
smoke detector using a 680 W EOL resistor. Connect one side to AUX PWR+ only if using a two-wire smoke. Refer to the wiring diagram. Program Location 37, Segment 6, Option 1. COM Common (-) terminal for zones 7 and 8. ZONE 7 Connect to one side of zone 7 loop. Connect the other side to the COM terminal. Open or short causes an alarm.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}