OPERATING INSTRUCTIONS - BITZER

Carbon dioxide CO 2 is heavier than air and should not be allowed to accumulate in low lying areas. Ensure that the current Material Safety Data Sheets for carbon dioxide CO 2 are on site. [See MSD attached] Melting point -56.6 °C Boiling point -78.5 °C Density 1.977kg /m3 Freezing point -56.6 °C Vapour Density 1.53 (air is 1)

  Carbon, Dioxide, Carbon dioxide

co // Semi-H ermetic 2 reciprocating comprESSorS

SuBcritical applicationS SuBKriti ScHe anwendun Gen application S SouS-critique S 50 Hz // K p-120-7 Subcritical High e fficiency co 2 // …

Kältemittel- REpoRT 18 - bitzer.de

Allgemeine Aspekte zur Kältemittel-Entwicklung Einführung Stratosphärischer Ozonabbau sowie atmos-phärischer Treibhauseffekt durch Kältemittel-

RefRigeRant REpoRT 19 - BITZER

Refrigerant Report Contents Essential revisions/supplements vs. 18 th edition Page 3 3 4 6 6 7 8 8 9 9 11 11 11 13 15 16 17 17 18 19 20 20 21 22 22 23 24 27 27 28 29 31 32 36 38 40 This edition supersedes all previous issues.

  Report, Refrigerant, Refrigerant report

TECHNICAL INFORMATION - BITZER

2 2 Construction With this type of motor the stator winding is separated into two parts – normally in Y/YY or Δ/ΔΔ connection. The both coil packets lay parallel to

CRII-System CRII System Système CRII - BITZER

2 1 Safety This Technical Information describes the function and control principle of the CRII system, its application ranges and system conditions as well

  System, Safety, Ciris, Crii system crii system, Crii system

WATER COOLED SHELL AND TUBE CONDENSERS

// Industrial water // Fresh water // Process water // Seawater // Ethylene glycol/water // Propylene glycol/water // CaCl 2 in water // Tyxofit 1.15 in water As a service, BITZER checks the suitability of the tube materials on presentation of a water analysis. The basis for the check is the current state of experience.

  Water, Fresh, Seawater, Fresh water

AIR COOLED CONDENSING UNITS - BITZER

of condensing units since 2016. The BITZER air cooled “LH.E” units meet the new criteria of July 2018 and con-vince due to optimized combination of fans and con-denser. They are available in modular construction of several extension levels with single compressors.

  Compressor, Unit

CO // SEMI-HERMETIC 2 RECIPROCATING COMPRESSORS

Smart electronics with easy application are added. The Line Start Permanent Magnet Motor (LSPM) improves the motor efficiency ... // The suction gas cooling for the power elements of the FI ensures an optimum temperature of the elec- ... pressure transmitters, temperature sensors, oil le vel switches, digital and ...

  Smart, Transmitter

SEMI-HERMETIC SCREW COMPRESSORS - BITZER

The semi-hermetic screw compressors of the HS. series are very versatile: they are suitable for low temperature refrigeration, for medium temperature ap-plication, for air conditioning and for heat pumps in commercial and industrial systems and in marine ap-plications. They have been developed both for single

  Compressor, Medium, Screw, Screw compressors

Operating Instructions - Shearwater Research

Operating Instructions Page 7 RevA 4.2. Turn On the Transmitter Turn on the transmitter by opening the tank valve The transmitter will automatically wake up when it detects pressure Pressure data is transmitted every 5 seconds 4.3. Turn Off the Transmitter To turn off the transmitter, close the tank valve and purge the

  Operating, Instructions, Valves, Operating instructions

Operating and Maintenance Instructions - Air Compressor

2. Close shut-off valve (block valve) between receiver and compressor, or receiver and plant air system, to prevent any back-up of air flow into the area to be serviced. 3. Lock open manual vent valve and wait for the pressure in the area to be serviced (compressor, receiver, etc.) to be completely relieved before starting service. The manual

  Operating, Instructions, Valves

Operating Instructions VT series - Becker Pumps

Operating Instructions Becker VT 4.4/8/10/16/25/40 Becker Pumps Corp. (888) 633‐1083 beckerpumps.com ... non-return valve (to avoid reverse rotation after switching off the vacuum pump), and locate the arrows that indicate correct rotation of motor/fan after electrical hook-up.

  Series, Operating, Instructions, Valves, Operating instructions, Operating instructions vt series

4. Leak Detection & Automatic Installation and • 1 Year ...

1. FloodStopPush the Open button to make sure Valve is open. • FloodStopWhen the Valve is opening or closing, you will hear the valve motor operating for a few seconds. 2. Saturate a rag with water and squeeze over Leak Sensor, or dip the Leak Sensor into a small bucket of FloodStopwater.

  Operating, Valves

Combination Proportioning Valve P/N 260-11179

Help: If after following the instructions, you still have difficulty with installing, bleeding, or adjusting your Wilwood Combination Proportioning Valve, consult your chassis builder, the retailer where the valve was purchased, a qualified brake technician, or Wilwood Customer Service at (805) 388-1188. 4.43 (112,4).35 (8,8) THRU P RESU 2 ...

  Instructions, Valves