Transcription of Part 2 Engineering Practices and Processes - Helitavia
{{id}} {{{paragraph}}}
Example: bachelor of science
Part 2 Engineering Practices and Processes - Helitavia
CAP 562 Civil aircraft Airworthiness Information and Procedures Part 2 engineering practices and processes Leaflet 2-1 Engineering Drawings 1 Introduction The purpose of an Engineering drawing is to record and convey the designer's requirements. The drawing must therefore, include sufficient information to enable production planning, manufacture, assembly, testing and inspection of the particular component or assembly to be carried out. So that there can be no misinterpretation of drawings, it is essential that both the person preparing the drawing and the person using the drawing should have a knowledge of the terms, symbols, abbreviations, and methods of presentation. This Leaflet gives general guidance on the various aspects of Engineering drawings and should be considered in conjunction with any special methods used by the design office responsible for a particular drawing.
CAP 562 Civil Aircraft Airworthiness Information and Procedures Part 2 Leaflet 2-1 Page 1 Part 2 Engineering Practices and Processes Leaflet 2-1 Engineering Drawings
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: