Transcription of Pico 4-Button Wireless Control INSTALL (041481)
{{id}} {{{paragraph}}}
Example: bachelor of science
Pico 4-Button Wireless Control INSTALL (041481)
pico 4-Button English Set-Up Operation Wireless Control 3 V- 10 mA (for Maestro Wireless and Cas taTM Wireless systems only). To communicate with other systems or devices, including RadioRA 2, HomeWorks QS, QS sensor module (QSM), Indicator LED. Mounting accessories sold separately. Flashes to indicate a For a complete listing of pico Wireless mounting Quantum , Serena Shades, and Sivoia QS, refer to the system button press or when unit accessories and more information about pico Wireless setup guides. is in programming mode. controls, please visit Important: Set up a pico Wireless Control to a dimmer / switch before use. 1. Press and hold the dimmer / switch Tap button or Off button (Figure 1) for approximately 6 seconds. Once the LED(s) start to blink slowly, release the Tap or Off button .
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: