Transcription of Pico 4-Button Wireless Control INSTALL (041481)
{{id}} {{{paragraph}}}
Example: dental hygienist
Pico 4-Button Wireless Control INSTALL (041481)
pico 4-Button English Set-Up Operation Wireless Control 3 V- 10 mA (for Maestro Wireless and Cas taTM Wireless systems only). To communicate with other systems or devices, including RadioRA 2, HomeWorks QS, QS sensor module (QSM), Indicator LED. Mounting accessories sold separately. Flashes to indicate a For a complete listing of pico Wireless mounting Quantum , Serena Shades, and Sivoia QS, refer to the system button press or when unit accessories and more information about pico Wireless setup guides. is in programming mode. controls, please visit Important: Set up a pico Wireless Control to a dimmer / switch before use. 1. Press and hold the dimmer / switch Tap button or Off button (Figure 1) for approximately 6 seconds. Once the LED(s) start to blink slowly, release the Tap or Off button . Zone Control Scene Control 2-Group Control 2.
same response to each button press of the Pico ® 4-Button wireless control. • Scene Control: Each dimmer / switch can be set to unique levels for a personalized effect. For more information, see Scene Control Operation. Replacing the Battery in a Pico ® Wireless Control 1. Place a flathead screwdriver into the slot at the bottom of the Pico ®
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: