Transcription of Pico 4-Button Wireless Control INSTALL (041481)
{{id}} {{{paragraph}}}
Example: tourism industry
Pico 4-Button Wireless Control INSTALL (041481)
pico 4-Button English Set-Up Operation Wireless Control 3 V- 10 mA (for Maestro Wireless and Cas taTM Wireless systems only). To communicate with other systems or devices, including RadioRA 2, HomeWorks QS, QS sensor module (QSM), Indicator LED. Mounting accessories sold separately. Flashes to indicate a For a complete listing of pico Wireless mounting Quantum , Serena Shades, and Sivoia QS, refer to the system button press or when unit accessories and more information about pico Wireless setup guides. is in programming mode. controls, please visit Important: Set up a pico Wireless Control to a dimmer / switch before use. 1. Press and hold the dimmer / switch Tap button or Off button (Figure 1) for approximately 6 seconds. Once the LED(s) start to blink slowly, release the Tap or Off button . Zone Control Scene Control 2-Group Control 2. Press and hold the Off button on the pico Wireless Control Default Light Levels P/N 041481 Rev.
de réglage d’éclairage envoyé par la commande sans fil Pico ®. • La commande sans fil Pico ® se trouve en-dehors du rayon de fonctionnement de 9 m (30 pieds). • La pile de la commande sans fil Pico ® est faible. • La pile de la commande sans fil Pico ® est installée de façon incorrecte. En mode de configuration, les DEL
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: