Transcription of Pico 4-Button Wireless Control INSTALL (041481)
{{id}} {{{paragraph}}}
Example: tourism industry
Pico 4-Button Wireless Control INSTALL (041481)
pico 4-Button English Set-Up Operation Wireless Control 3 V- 10 mA (for Maestro Wireless and Cas taTM Wireless systems only). To communicate with other systems or devices, including RadioRA 2, HomeWorks QS, QS sensor module (QSM), Indicator LED. Mounting accessories sold separately. Flashes to indicate a For a complete listing of pico Wireless mounting Quantum , Serena Shades, and Sivoia QS, refer to the system button press or when unit accessories and more information about pico Wireless setup guides. is in programming mode. controls, please visit Important: Set up a pico Wireless Control to a dimmer / switch before use. 1. Press and hold the dimmer / switch Tap button or Off button (Figure 1) for approximately 6 seconds.
button press or when unit is in programming mode. Zone Control On Button Lights brighten ON to full intensity. Raise Button Lights increase in intensity. Lower Button Lights decrease in intensity. Off Button Lights dim to OFF. Scene Control Scene Buttons Tap once: Sends device to preset levels. Press and hold for 6 seconds: Saves new scene. Off ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: