Transcription of Pipes, Fittings and Accessories - GFPS
{{id}} {{{paragraph}}}
GF Piping Systems GF Revit Pipes, Fittings and Accessories GFDO_MA_00086 / EN / 0a (04/2021) Georg Fischer Piping Systems Ltd 8201 Schaffhausen/Switzerland GF Revit Pipes, Fittings , and Accessories e-Manual 2 Table of contents 1. General Information .. 3 Integrity of pipes, Fittings and Accessories .. 3 Irregular sizes .. 3 Naming Convention .. 3 2. Pipes .. 3 Single or multi-layer pipes .. 3 Pipes with soft 4 Pre-Insulated Pipes (pipes with hard shell) .. 4 Double-containment pipes .. 4 3. pipe Fittings .. 4 Couplers, sockets, unions, and other variations .. 4 Endcaps .. 5 Bends and elbows .. 5 Tees .. 5 Crosses .. 5 Saddles .. 5 Transitions and adapters .. 6 Reducers and reducing bushes.
3.7. Transitions and adapters The basic premise of transitions, adapters and their variations is to connect different sizes with different systems, however, from time to time some these products have the same connecting diameter on both ends. To avoid malfunctions in Revit while using the same sizes on both ends for transitions defined in
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}