Transcription of Polycom OBi300 Installation and Configuration Guide
{{id}} {{{paragraph}}}
Example: air traffic controller
Polycom OBi300 Installation and Configuration Guide
Polycom OBi300 Installation and Con guration GuideInstallation Requirements1 Check that you have the following: Polycom OBi300 device Ethernet cable Power adapterYou also need: Touch-tone phone Active Internet connection Access to the Internet via an Ethernet port on your router or modem (Optional) Internet phone service subscriptionMake a Test Call Using Polycom OBiTALK3 Install the Polycom OBi300 Device2At any time, you may place a test call to the OBiTALK test number:Dial **9 followed by: Follow these steps to install the Connect phone to the green PHONE port using the phone s original RJ-11 telephone line Connect one end of the Ethernet cable to the blue INTERNET port and the other end to an Ethernet port on your router, broadband modem, or Ethernet Connect the power adapter to the OBI device power jack and a power OBi300 RearPolycom OBi300 ConnectionsEthernet Cable O : No powerSolid green: Powered on and workingFlashing green: Searching for a DHCP IP addressFlashing orange: Upgrading (do not unplug power)Solid red: Not operationalFlashing green (Intermittent): Data activity on the internet Ethernet port O : Port
1. Connect phone to the green PHONE port using the phone’s original RJ-11 telephone line cable. 2. Connect one end of the Ethernet cable to the blue INTERNET port and the other end to an Ethernet port on your router, broadband modem, or Ethernet switch. 3. Connect the power adapter to the OBI device power jack and a power outlet. 1725-85343-001C
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: