Transcription of POLYETHYLENE FITTINGS
{{id}} {{{paragraph}}}
Example: barber
POLYETHYLENE FITTINGS
Building essentials for a better tomorrow MDPE & HDPE FITTINGS MEET ASTM D2513, D2683, D3261 METFIT FITTINGS MEET ASTM D2513, F1924 POLYETHYLENE FITTINGSPRICE LISTPRICE LISTPOLYETHYLENEFITTINGSMDPE & HDPE FITTINGS MEET ASTM D2513, D2683, D3261 MetFit FITTINGS MEET ASTM D2513, F1924 MATERIAL DESIGNATION CODES AND APPLICAbLE STANDARDSAll USPoly fusion FITTINGS are produced from a resin listed in PPI's (Plastic Pipe Institute) TR-4 listing of approved material designation code for MDPE UAC 2000 FITTINGS is PE 2406/PE 2708, with a recommended hydrostatic design basis (HDb) of 1250 PSI @ 73 degrees material designation code of HDPE FITTINGS is PE 3408/PE 3608/PE 4710, with a recommended hydrostatic design basis (HDb) of 1600 PSI @ 73
included. Add $0.86 each when sleeves are included for sizes ½" CTS to ¾" IPS. Add $1.44 each for 1" CTS and 1" IPS. Add $2.48 each for 1-¼" IPS size. Additionally, emery cloths and alcohol wipes are available upon request for an additional cost. note: IPS is used throughout this catalog unless CTS is designated.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: