REVISION CF SSW-1XX-XX-XXX-X-XX-XXX-XX

this document contains confidential and proprietary information and all design, manufacturing, reproduction, use, patent rights and sales rights are expressly reserved by …

  Xx xxx x xx xxx xx

HIGH MATING FTSH–125–01L–DVEJ CYCLES SMT …

(1.27 mm) .050" FTSH–125–01L–DVEJ FTSH–120–01F–DV FTSH110–01–L–DV m . A Sm . Cm m m Sm Sm m . WWW.SAMTEC.COM For complete specifications and

(1.27 mm) .050 FTS SERIES MICRO LOW-PROFILE …

(1.27 mm) .050" FTS SERIES FTS1102L FTS11002FV FTS12201FV FTS11102LVSA Mates with socket strips or IDC cable Impedance matched for high-speed applications

  Series, Profile

REVISION AO FFSD-XX-X-XX.XX-01-X-X-XXX

this document contains confidential and proprietary information and all design, manufacturing, reproduction, use, patent rights and sales rights are expressly reserved by …

  Revisions, Ffsd xx x xx, Ffsd, Xx 01

SFM110–02–L–D–A SFML125–T2–LD–LC …

(1.27 mm) .050" SFML125–T2–LD–LC SFM–125–02–L–SH SFM110–02–L–D–A SFML115–T2–LD–LC Choice of SMT or through-hole tails Locking feature

  Sfm110 02 l d a sfml125 t2 ld lc, Sfm110, Sfml125

HIGH MATING CYCLES THROUGH-HOLE MICRO …

(1.27 mm) .050" FTSH SERIES Im m f applications ( CLP S) sock ips IC le T r surf m (2.51 mm) .0" O (1.27 mm) .050" m FTSH–120–02–L–D FTSH–120–01–L–D–RA

  Ftsh

REVISION J - Samtec Microelectronics

1.95049.53.05001.270.45011.43.0350.89 (typ) cl cl 01 all dimensions are symmetric about the centerline. notes: stencil to be .0060[.152] thick. a k j h

  Dimensions

HIGH MATING CYCLES HTSW115–05–LQ TSW–209–09F–SRA …

tsw, htsw series tsw–112–07–g–t tsw10910–f–d–ra htsw12013–t–d tsw–11416g–sre, , m . a sm . cm m m sm sm m .

HIGH MATING CYCLES LOW-PROFILE DUAL WIPE SOCKET

(1.27 mm) .050" CLP SERIES T Cw contacts CLP–107–02–F–D–P CLP–130–02–L–D CLP–116–02–F–DH CLP–115–02–L–D S m Lw-pro˜le

HIGH MATING CYCLES (2.54 mm) .100 SMT .025 SQ POST …

tsm series tsm–115–01–t–sh–a tsm–12–02–l–dh–k tsm110–01–t–dv m . a sm . cm m m sm sm m . www.samte.om

  Series

Snubber Circuits Suppress Voltage Transient Spikes in ...

The RC network may be replaced by a zener diode that can handle the voltage rating and the power dissipation. However, since the zener is not a fast switching device a capacitor may still be needed in parallel with the zener to handle the high frequency currents. Note that this snubber is not used in Page 5 of 9

  Ratings, Voltage, Voltage ratings

Automatic Voltage Regulator User’s Manual

the input rating and voltage shifting based on load current. This is based on AVR’s internal circuit calculation. This way the AVR increases or decreases the voltage. When phase current lags the voltage, AVR decreases original voltage setting, and if the phase current leads the voltage it increases the original voltage setting.

  Ratings, Voltage

Transient Voltage Suppressors (TVS) for Automotive ...

above conditions, the supply voltage at a 300 mA load is 8.4 V at R = 20 Ω, and 11.4 V at R = 10 Ω at a minimum voltage of battery of 14.4 V (24 V battery voltage in - 18 °C). Power rating of R = I2R This supply voltage is higher than the minimum input voltages for most voltage regulators and DC/DC converter ICs. Protected Load-TVS Current V ...

  Ratings, Voltage

Low voltage motors Installation, operation, maintenance ...

Check all rating plate data, especially voltage and winding connections (star or delta). The type of bearing is specified on the rating plate of all motors except the smallest frame sizes. In the case of a variable speed drive application check the maximum loadability allowed according to frequency stamped on the motor’s second rating plate.

  Ratings, Voltage

NON-CONTACT VOLTAGE TESTER (NCVT-1) OwNER’S …

• A blinking or steady red glow and an audible beep indicate voltage present. If no indication, voltage could still be present. • Before and after each use, verify operation by testing a known working circuit that is within the rating of this unit. • Never assume neutral or ground wires are de-energized. Neutrals in multi-wire

  Contact, Ratings, Voltage, Tester, Tcvn, Non contact voltage tester, Ncvt 1

Motor control centers— low voltage

Low-voltage power distribution and control systems > Motor control centers > Motor control centers— low voltage Contents ... so that an arc rating can be achieved. The combination of devices includes all the standard Freedom devices less a handful, which are covered under the

  Ratings, Voltage

DUAL RANGE NON-CONTACT VOLTAGE TESTER (NCVT-2) …

SPECIFICATIONS: VOLTAGE RANGE: 12-1000 Volts AC TESTER TYPE: Non-Contact Voltage Detector UL CERTIFICATION E321008 3TMV FREQUENCY RANGE: 50-500Hz STANDARDS: UL 61010-1 2nd edition, CAN/CSA C22.2 No. 61010-1-04, EN 61010-1 2nd edition, IEC 61010-1:2001 2nd edition, ISA-82.02.01 (IEC61010-1 MOD)

  Voltage